Receiver Operation:
Battery Test
Indcator
Battery 
Level Mark 
Receiver Front Panel
DynatelTM
2210 |
|
577 Hz | 33 KHz |
On
Off |
|
| Hz |
Gain Adjust | Depth | Freq |
1.Press 
to turn receiver on and see battery level. Hold down 
for continuous Battery Test. If bar graph is to the left of the battery level mark, replace batteries. Note: when
batteries are low, the battery test indicator 
remains on.
2.Press 
to match Frequency to transmitter output or select 
for passive power locating.
3.Press 
to set Gain when bar graph is not visible or is closed. For High Volume (
),
hold down 
while turning unit on. To return to normal volume, turn unit off, then on again.
4.Make broad sweeps with receiver handle in line with target cable path to get maximum bar graph closure; press 
. Maximum bar graph and numeric indication occurs directly over cable.
5.Place the receiver upright on the surface directly over cable. With handle parallel to
path, press 
to display estimated Depth. Press again to display numeric Current 
indication. Cable with highest current indication is the target. Press 
to return to trace mode, and press 
. Unit returns to trace mode automatically after eight seconds.
Note: Active Duct Probe (sonde) depth will differ from cable depth due to the shape of the electromagnetic field of the ADP. Conversion tables are provided with the ADP to obtain accurate depth estimates.
Battery Installation
6 `C' cells |
6 `AA' |
cells |
3