How to Prepare Hookup Cables

The McIntosh XRT28 Loudspeaker System utilizes bind- ing posts for speaker wire connections. Prepare the Loud- speaker Hookup Cables that attach to the Power Amplifier Output Terminals:

Bare wire cable ends:

Carefully remove sufficient insulation from the cable ends, refer to figures 19, 20 & 21. If the cable is stranded, carefully twist the strands together as tightly as possible.

McIntosh Single Channel Amplifier

Note: If desired,

the twisted ends can be

tinned with

solder to keep the

strands together and/or attach a spade lug.

Spade lug or prepared wire connection:

Insert the spade lug connector or prepared section of the cable end into the terminal side access hole, and tighten the terminal cap until the cable is firmly clamped

into the terminal so the

wires cannot

slip out. Refer to figures 22, 23 & 24.

How to Connect using a single Amplifier

1.Connect a Loudspeaker cable from the Negative (-) Binding Post of the Amplifier to the XRT28 Loud- speaker System LOW COMmon (-) Binding Post.

2.Connect a Loudspeaker cable from the Positive (+) Binding Post of the Amplifier to the XRT28 Loud- speaker System LOW 4S (+) Binding Post.

Note: For full audible range operation, jumpers must be in place between the MID and HIGH COMmon (-) Binding Posts, the MID and HIGH 4S (+) Binding Posts, the MID and LOW COMmon (-) Binding Posts and the MID and LOW 4S (+) Binding Posts.

3.Tighten all of the Loudspeaker and Amplifier Binding Posts.