Stiga 33 manual Symbols, Battery, Assembly, General

Page 4

ENGLISH

GB

 

 

SYMBOLS

The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine.

The symbols mean:

Warning! Read the Instruction Book and Safety Manual before using the machine.

Warning! Keep spectators away. Beware of objects being flung out.

Warning! Take out the safety key before any type of maintenance is carried out.

Warning! Do not put hands or feet under the cover of the machine when it is running.

Warning! The blades continue to rotate even after the machine has been switched off.

STOP

STEERING (fig. 2)

1.Insert the tubes into the ends of the handlebar.

2.Fit the screws. Tighten securely.

3.Insert the ends of the U tube into the holes in the chassis.

4.Fit the screws. Tighten securely.

5.Attach the handle to the U tube using the bolts, washers and locking knobs provided. The han- dlebar can be folded forwards by undoing the locking knobs slightly. This reduces the space the mower takes up during transport, etc.

6.Secure the electrical cable into the cable holder.

7.Fix the electrical cable using a cable tie.

GRASS COLLECTOR (fig. 3)

1.Snap-together the grass collector's upper and lower parts.

2.Open the cover on the machine and hook the grass collector onto the chassis.

Note! The lawn mower can be used without the grass collector. The grass will then collect in a bead behind the machine.

BATTERY

When a red lamp lights up on the mower’s control panel and/or a sound signal is acti- vated, take out the safety key.

ASSEMBLY

WHEELS/CUTTING HEIGHT (fig. 1)

1.Insert the wheel bolt A in the hub cap B.

2.Snap-on the centre cup C.

3.Place a bushing on each side of the wheels (only the back wheels).

4.Fit the wheel in one of the fixing plate's four po- sitions.

5.Tighten securely by hand using the finger-grip holes in the hub cap.

Note! The same cutting height should be set on all four wheels.

GENERAL

Before starting the mower for the first time and after winter storage, you should charge the battery for 1 - 2 days other- wise the battery can be damaged.

In order for the battery to maintain its capacity and to give optimum perform- ance, it is important that the charging and storage instructions are carefully fol- lowed.

The battery used in this machine is a lead-acid type battery. This type of battery must always be stored fully charged.

Always charge the battery indoors, in a garage, etc. where the battery is dry and protected from the weather.

Only charge the battery when the temperature is at least 0°C and not over +40°C. Charging in lower or higher temperatures can damage the battery.

Image 4
Contents Silent ∅ 130 mm 160 mm 36 mm 19 mm Symbols BatteryAssembly GeneralUsing the Mower Charging InstructionsCharging Before Winter Storage STARTING/STOPPING the MowerMaintenance CleaningMowing Tips Changing the BladeProblem Possible causes