Stiga 8211-0225-06 manual Symbols, Using the Mower, Assembling

Page 5

GB

ENGLISH

 

 

SYMBOLS

The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine. The symbols mean:

Warning! Read the Instruction Book and Safety Manual before using the machine.

Warning! Keep spectators away. Beware of objects being flung out.

Warning! Do not put hands or feet under the cover of the machine when it is run- ning.

Warning! Before starting any repair work, remove the spark plug cable from the spark plugs.

IMPORTANT

USING THE MOWER

BEFORE STARTING

FILL THE CRANKCASE WITH OIL

The lawn mower is delivered without any oil in the motor crankcase. The crank- case must, therefore, be filled with oil be- fore the motor is started the first time.

Remove the oil dipstick (fig. 3,4). Fill the engine's crankcase with 0.6 litres of good quality oil (serv- ice class SE, SF or SG) Use SAE 30 or SAE 10W- 30 oil.

Fill until the oil reaches the “FULL/MAX” mark on the dip stick. Do not fill with too much oil.

CHECKING THE OIL LEVEL

Check before using the machine that the oil level is between “FULL/MAX” and “ADD/MIN” on the dipstick.

Remove and dry the dipstick (fig. 3,4). Slide it down completely and tighten it. Unscrew and pull it up again. Read-off. If the oil level is low, fill with oil up to the “FULL/MAX” mark.

FILL UP THE PETROL TANK

Certain models do not have a throttle. The motor speed is set for optimal function and minimal ex- haust emissions.

ASSEMBLING

EJECTION SHIELD

Under no condition must the machine be started without the ejection shield being fitted on the machine. If it is not fitted, stones and other flying objects may eas- ily be ejected by the rotating blade.

Fit the ejection shield in the holes on the chassis with the help of two nuts. Tighten the nuts fully (fig. 1).

HANDLEBAR

Move the upper part of the steering handle up- wards and tighten the locking knobs (fig. 2). The height of the handle can be adjusted in three differ- ent positions.

Fill with petrol before starting the mo- tor. Never remove the filler cap or fill with petrol while the motor is running or still warm.

Never fill the fuel tank completely full but allow a little room for the petrol to expand.

Always use pure unleaded petrol. You must never use 2-stroke petrol mixed with oil.

Note that you should always remember that petrol is a perishable commodity. Never buy more petrol than what you can use up in 30 days.

STARTING THE ENGINE

Keep hands and feet well away from the rotating blade(s). Never put your hand or foot under the blade casing or in the grass evacuation unit while the motor is running.

1.Place the lawn mower on flat, firm ground. Do not start in high grass.

2.Make sure the spark plug lead is connected to the spark plug.

Image 5
Contents Tornado XTE 40 Nm Page Assembling SymbolsUsing the Mower Cleaning MaintenanceIN/ OUT Coupling of the Drive Stop of EngineLubrication Cooling SystemChanging OIL AIR FilterStorage Adjustment of the Clutch WireChanging Blades Sharpening of the Blades