Figure 16. Turntables feeding low-level inputs.
OUTPUT CONNECTIONS
There are two sets of outputs on the left half of the back panel. (See Figure 15) One pair is marked M A I N . The second pair is markedTAPE.
The M A I N outputs connect to power amplifiers (figure 17). The TAPE output feeds
a tape | recorder. |
The | M A I N jacks are fed from cathode |
followers. Longer cables than are normally supplied can be connected between the C22 and the amplifiers. The length of the cable is limited by the capacity of the cable. The total capacity must not exceed 1000 mmf. For
instance: cables with a capacity of 25 mmf per foot may be 40 feet long; 13.5 mmf per foot cable may be 75 feet long. The input impedance of the amplifiers should be 50,000 ohms or greater.
The TAPE output is fed from a cathode follower. The program material fed out of the TAPE output is not affected by these front panel controls: VOLUME control, BASS con- trols, LF and HF filter switches, BALANCE control, LOUD switch, TAPE switch, PHASE switch, TREBLE controls, and MODE SELEC- TOR switch.
The program material fed out of the TAPE output is affected by these front panel con-
Figure 17. MAIN OUTPUT Connected to Power Amplifiers.
10