Stiga 125 COMBI PRO manual Introduction, Assembly, Using the Machine

ENGLISHGB

SYMBOLS

The following symbols appear on the machine. They are there to remind you of the care and atten- tion required in use.

This is what the symbols mean:

Warning!

Read the instruction manual and the safety manual before using the machine.

Warning!

Do not insert your hands or feet under the cover when the machine is in operation.

Warning!

Watch out for discarded objects. Keep on- lookers away.

Warning!

Before starting repair work, remove the spark plug cable from the spark plug.

Warning!

To minimise the risk of tipping over, frame weights should be in- stalled on the machine when using the cutting deck.

side of the machine (fig. 4).

6.Set the maximum cutting height.

7.Force the V-belt onto the machine’s centre pul- ley A (fig. 5).

8.Lift the rear edge of the cutting deck and secure with the pins (fig. 2). The basic setting for ma- chines with 17“ tyres is position 3.

9.Tension the belt with the belt idler B. The belt idler should be on the left side of the belt viewed from the driver’s position (fig. 5).

10.Secure the lift spring’s snap hook in the imple- ment lifter (fig. 6). The position of the snap hook can be varied by threading it into different links in order to achieve better lifting height or to follow the ground better.

11.Secure the S-hook to one of the inner holes on the implement lifter.

SETTING

In order for the deck to cut evenly and attractively, it has to be correctly adjusted:

1.Make sure the air pressure in the tyres is correct: Front: 0.6 bar (9 psi).

Rear: 0.4 bar (6 psi).

2.Place the machine on a level floor. Undo the pins (fig. 2).

INTRODUCTION

The cutting deck is available as standard in two versions:

-with mechanical setting of the cutting height (item no. 13-2936).

-with factory-fitted, electrical setting of the cut- ting height (item no. 13-2937).

ASSEMBLY

CUTTING DECK

1.Install the deck mounts on the machine’s steer- ing knuckles (fig. 1).

2.Place the cutting deck in front of the machine.

3.Remove the pins (fig. 2).

4.Screw the cutting deck into the deck mounts (fig. 3).

5.13-2937:

Connect the electrical contact to the socket on the

3.Adjust the deck so that the front and rear edge of the cover are the same height above the floor.

4.Secure with the pins.

USING THE MACHINE

COMBI

Your new cutting deck combines two different functions in the same product:

1. “MULTICLIP”

The machine comes equipped with a plug installed in the ejector opening (fig. 7). The cutting deck can be used for “Multiclip” i.e. the blade finely cuts up the grass during mowing. The grass then falls into the lawn where it is allowed to rot. This provides the lawn with nourishment.

To remove the plug, the cutting deck must first be folded up into the service position (see heading SERVICE POSITION). Then unscrew the plug.