Stiga 110 S manual Symbols, Preparation, Assembly, Use

ENGLISH GB

SYMBOLS

The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine.

The symbols mean:

Warning!

Read the instruction book and safety man- ual before using the machine.

Warning!

Do not put hands or feet under the cover of the machine when it is running.

Warning!

Beware of objects being flung out. Keep spectators away.

Before starting any repair work, remove the spark plug cable from the spark plug.

PREPARATION

If this clipping unit is used with the Park model, the number of revolutions per minute should be re- duced slightly in order to comply with the current regulations for approved noise levels:

-Senator and President models: reduce to 3,000 rpm

-Royal, Pro 16, Pro 18 and Pro 20 models: re- duce to 3,200 rpm

This adjustment to rpm should only be made by the retailer or at an authorised workshop, i.e. by people who have the correct skills and equipment.

ASSEMBLY

MOWER DECK

1.Fit the support wheels and the deflector as show in figure 1.

2.Fit the attachment brackets D on the front axle

studs by using the washers and locking clips (fig 2).

3.Slide in the attachment's fixing arms into the ma- chine's attachment brackets.

4.Set the v-belt on the machine's central belt pulley F (fig 3).

5.The tension roller G should rest on the left-hand side of the v-belt, seen from the driver's seat (fig 3).

6.Now pull the mower deck forwards so that the holes in the fixing arms correspond with the holes on the attachment brackets.

7.Insert the screws and tighten.

8a. Park -1999:

Hook the tension roller spring H into the floor on the right-hand side (fig 3).

8b. Park 2000-

Hook the tension roller spring H into the fastener, just behind the front right wheel (fig 3).

9.Lift up the mower deck and hook the chain into the attachment lifter.

When changing the v-belt or dismantling the mower deck follow the above procedures in the reverse or- der.

SETTING

1.Check that the tyres have the correct air pressure. Front: 0,6 bar (9 psi).

Rear: 0,4 bar (6 psi).

2.To obtain an even cut from the mower deck its forward and rear edges must be parallel to the ground.

- Check this by placing the machine on a flat sur- face.

-If adjustment is required, adjust using the washers I at the support wheels (fig 1).

Points 1 and 2 must be carried out for the mower deck to mow evenly.

USE

MOWING HEIGHT

The mower deck has 17 fixed mowing heights, from 30 mm to 80 mm.

N.B. The stated mowing heights apply when the machine is standing on firm ground.