Electrical General Instructions | Strong Pools and Spas St. Martin

Electrical - General Instructions

It is recommended that a licensed electrician install the power to your spa, in accordance with the National Electric Code or any local electrical codes in effect at the time of installation.

Power supply installation must include a properly rated GFCI circuit breaker. The circuit breaker must be dedicated and cannot be shared with any other appliances. It should be labeled and easily accessible to users. Power supply must be hard wired into the power pack. DO NOT USE EXTENSION OR PLUG-TYPE CORDS OF ANY KIND. The use of a shut-off box near the spa is recommended. Metal surfaces within 5 feet of the spa must be grounded to the spa.

220V St. Martin Electrical Connections:

This change must be performed by a certified electrician.

			L1

			L2
	Three Wire		L2
	Three Wire
	& Ground		N

TERMINAL

BLOCK

These wires go to the PC Board Control Circuit.

GRD

Connections should be made using copper conductors only. The connecting wire and circuit breakers or fuses must be sized to accommodate the total ampere load as specified on the equipment module data label.

Strong Pools and Spas only makes electrical recommendations, always consult a certified electrician.