OPERATING INSTRUCTIONS - Cont'd
15.For high pressure cleaning, install the 15°, 25°, or 40° nozzle to the gun wand.
16.Point the wand towards the object to be cleaned and squeeze the trigger to start the motor and begin cleaning.
NOTE: This power washer is equipped with Automatic Total Stop®, a stop device which will sense when the trigger on the gun is released. It will open the power circuit to the motor and cause the power washer to stop.
DANGER: If Automatic Total Stop® fails to operate, DO NOT USE THE MACHINE. Contact our Customer Service department. Further use will damage the machine and/or cause personal injury.
DANGER: Operating a power washer that doesn't have proper water flow could result in an explosion. If water should stop flowing from the gun, turn unit off immediately and contact our Customer Service department.
DANGER: This power washer is equipped with a main power ON/OFF switch located on the unit. It should always be moved to the OFF position when the power washer
is not being used to prevent possible injury or damage.
17.For chemical application,
1.Place the chemical suction tube into a container of power washer cleaning solution.
USE ONLY APPROVED POWER WASHER CLEANERS. DO NOT USE BLEACH, CHLORINE, OR ANY CLEANERS CONTAINING ACIDS.
2.Connect the black low pressure nozzle to the gun wand quick connect.
3.Point the wand towards the object to be cleaned and squeeze the trigger to start the motor and begin cleaning.
DANGER: Allowing the detergent level to fall below the chemical feed line opening feeds air into the system which could cause a steam explosion. Air introduced into the system will cause pump damage and create steam space if the burner is on. The detergent level should never fall below the chemical feed line opening.
Page 9 |