SIIG 16556380 manual Hardware Installation, Layout

Page 2

Layout

The 1x2 VGA Splitter's image is shown below. The 4-port and 8-port models come with 4 and 8 outputs, respectively.

On/Off switch

 

 

 

 

 

 

 

 

 

 

 

 

Power adapter jack

PC

(input)

 

 

 

 

 

 

 

MONITOR (output)

 

 

 

Figure 1: Rear Panel

Note: To daisy chain, connect the MONITOR port of the first splitter to the PC port of the next splitter.

Hardware Installation

1.Power off the computer and monitors you plan to connect to this splitter.

2.Connect your computer’s VGA out to the splitter’s PC connector using a VGA cable (not included).

3.Connect your VGA monitors to the splitter’s MONITOR connectors using VGA cables (not included).

4.Connect the splitter’s power adapter.

5.Turn on the monitors, then computer.

6.The VGA Splitter is now ready to use.

2

Image 2
Contents Introduction the VGA Splitter Features and BenefitsPackageContents Hardware Installation LayoutTechnical Support and Warranty SIIG, Inc Stewart Avenue Fremont, CA 94538-3152, USA RMA #About SIIG, Inc