Shindaiwa X7502831200 manual Filling the fuel tank, After use, Minimize the Risk of Fire

Page 10

Mixing Instructions

1.Fill an approved fuel container with half of the required amount of gasoline.

2.Add the proper amount of engine oil to gasoline.

3.Close container and shake to mix oil with gasoline.

4.Add remaining gasoline, close fuel container, and remix.

IMPORTANT!

Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut- off containers to reduce fuel spillage.

After use

■■DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.

Storage - Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, airtight con- tainer. Store in a well-ventilated, unoccupied building, away from sparks and flames.

IMPORTANT!

Stored fuel may separate. ALWAYS shake fuel container thoroughly before each use.

Filling the fuel tank

WARNING!

Minimize the Risk of Fire

NEVER smoke or light fires near the engine.

ALWAYS stop the engine and allow it to cool before refueling.

ALWAYS Wipe all spilled fuel and move at least 3 meters (10 feet) from the fueling point and source before starting.

NEVER place flammable material close to the engine muffler.

NEVER operate the engine without the muffler and spark arrester screen in place and in good working condition.

FUEL IS HIGHLY FLAMMABLE.

ALWAYS store gasoline in a container approved for flammable liquids.

ALWAYS inspect the unit for fuel leaks before each use. During each refill, check that no fuel leaks from around the fuel cap and/or fuel tank.

If fuel leaks are evident, stop using the unit immedi- ately. Fuel leaks must be repaired before using the unit.

ALWAYS move the unit at least 3 meters (10 feet) away from a fuel storage area or other readily flam- mable materials before starting

the engine.

1.Place the unit on a flat, level surface.

2.Clear any dirt or other debris from around the fuel filler cap.

CAUTION!

Slowly remove the fuel cap only after stopping the engine

3.Remove the fuel cap, and fill the tank with clean, fresh fuel.

4.Reinstall the fuel filler cap and tighten firmly.

5.Wipe away any spilled fuel before starting engine.

10

Image 10
Contents T344 Trimmer Contents IntroductionStay Alert SafetyWork Safely Use Good JudgmentSafety Labels Properly Equipped OperatorProduct Description Be Aware of the Working EnvironmentPrior to Assembly SpecificationsAssembly Emission Control Exhaust & EvaporativeCutting attachment shield Install trimmer headNylon line replacement To advance trimmer line TipFront handle installation Adjust throttle lever free playMixing Fuel Fuel RequirementsAfter use Filling the fuel tankMinimize the Risk of Fire Starting the Engine Checking Unit Condition When the Engine StartsStopping the Engine Starting a Flooded EngineOperation Maintenance Remove and clean or replace the spark plug Hour maintenance More frequently in dusty conditions10/15-Hour maintenance Hour maintenance Gear HousingHour maintenance Remove and replace the fuel filter element Hour Maintenance Valve AdjustmentSpark Arrester Screen Maintenance Carburetor AdjustmentLong Term Storage Idle Speed AdjustmentTrimmer head is now fully loaded and ready for operation Troubleshooting Guide Possible CauseIs the engine overheating? Symptom Possible Cause Remedy Exceptions 99922201031 02/05/2010 01/2010 Page Page Servicing Information Parts/Serial Number