Mixing Instructions
1.Fill an approved fuel container with half of the required amount of gasoline.
2.Add the proper amount of engine oil to gasoline.
3.Close container and shake to mix oil with gaso- line.
4.Add remaining gasoline, close fuel container, and remix.
IMPORTANT!
Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut- off containers to reduce fuel spillage.
After use
•DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel stor- age container.
Storage - Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, airtight container. Store in a
IMPORTANT!
Stored fuel may separate. ALWAYS shake fuel con- tainer thoroughly before each use.
Filling the Fuel Tank
WARNING!
Minimize the Risk of Fire ■■NEVER smoke or light fires near
the engine.
■■ALWAYS stop the engine and allow it to cool before refueling.
■■ALWAYS Wipe all spilled fuel and move at least 3 meters (10 feet) from the fueling point and source before starting.
■■NEVER place flammable material close to the engine muffler.
■■NEVER operate the engine without the muffler and spark arrester screen in place and in good working condition.
■■FUEL IS HIGHLY FLAMMABLE.
■■ALWAYS store gasoline in a container approved for flammable liquids.
■■ALWAYS inspect the unit for fuel leaks before each use. During each refill, check that no fuel leaks from around the fuel cap and/or fuel tank. If fuel leaks are evident, stop using the unit immediately. Fuel leaks must be repaired before using the unit.
■■ALWAYS move the unit at least 3 meters (10 feet) away from a fuel storage area or other readily flam- mable materials before starting the engine.
1.Place the unit on a flat, level sur- face.
2.Clear any dirt or other debris from around the fuel filler cap.
CAUTION!
Slowly remove the fuel cap only after stopping the engine.
3.Remove the fuel cap, and fill the tank with clean, fresh fuel.
4.Reinstall the fuel filler cap and tighten firmly.
5.Wipe away any spilled fuel before starting engine.
Starting the Engine
IMPORTANT!
Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF or STOP.
NOTE:
The blade cover is used for transportation and storage. Remove blade cover before using the unit.
WARNING!
Never start the engine from the operating position.
11