Rear Panel Connections

Connect the MA7000 power cord to a live AC outlet. Refer to information on the back panel of your MA7000 to determine the correct voltage for your unit

EXT SENSOR con- nector permits the connection of a Mc- Intosh IR Sensor for remote operation

GND	JUMPER PLUGS
terminal	connect the Pream-
accepts	plifier OUTPUT 1
a ground	Jacks to the PWR
wire from a	AMP IN Jacks
turntable	and are needed for
	normal operation

OUTPUT 2 sends balanced signals to a separate exter- nal Power Amplifier with balanced inputs

POWER CON- TROL MAIN Out- put sends a turn-on signal to a McIn- tosh Component when the MA7000 is turned On

RIGHT OUTPUT connections for a 2, 4 or 8 ohm loudspeaker

CD1 and DVD Bal- anced and Unbalanced INPUTS accept high level program source signals

LEFT OUTPUT connections for a 2, 4 or 8 ohm loudspeaker

Main Fuse holder, refer to information on the back panel of your MA7000 to determine the cor- rect fuse size and rating

POWER CONTROL 1 and 2 Output sends a turn-on signal to a McIntosh Component when the Outputs 1 and 2 Push-buttons are used

PHONO accepts	PWR AMP
signals from a	input accepts
Moving Magnet	signals from
phono cartridge	the internal
	Preamplifier
	or a separate
	external Pre-
	amplifier

RECord OUTPUT sends signals to the input of a recording device

POWER CONTROL ACC	DATA PORTS send	CD2, SERVER,
Output sends a turn-On,	signals to McIntosh	REC and TUNER
turn-Off signal to a McIn-	Source Components	INPUTS accept high
tosh Component when using	to allow control with	level program source
the MA7000 Remote Control	the MA7000 Remote	signals
ACC On/Off Push-buttons	Control

OUTPUT 1 sends signals to the internal Power Amplifier or a separate external Power Amplifier