Applying Chemicals

Operation Instructions

1.) Push the nozzle forward for low pressure to spray chemicals onto the cleaning surface.

2.) Start the pressure washer according to the start-up instructions.

3.) Submerge the chemical hose and chemical strainer in cleaning solution.

4.) Squeeze the spray gun trigger. The chemical injector will draw the cleaning solution into the water stream.

5.) Apply chemicals evenly onto the cleaning surface. Allow the chemicals to react with the dirt, then clean at high pressure by pulling the nozzle backward.

6.) Never use more chemical than is necessary to clean the surface.

7.) Rinse chemical injector by following steps 1 through 4 with clean water.

Chemical hose

Cleaning solution

Chemical strainer

WARNING

Risk of exposure to dangerous chemicals.

Serious injury or death can result if chemical manufacturer instructions are not followed.

-Wear protective gloves when handling and cleaning with chemicals.

-Understand all safety hazards and first aid for all chemicals being used. -When cleaning filters, check if chemicals have been used and take any precautions that are recommended by the chemical manufacturer.

-Different chemicals may interact dangerously with each other, always follow chemical manufacturer directions before switching chemicals.

-Calculate the correct amount of chemical to mix, dispose of excess chemical per the manufacturer instructions.

-Never spray flammable liquids.