Napoleon Grills PTHC38PK manual Storage/Cleaning

STORAGE :

Between uses:

Turn the control knob to "OFF " position.

Turn LP cylinder to "OFF "position.

Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).

If desired, cover heater to protect ecterior surfaces and to help prevent build up in air passages.

During periods of extended inactivity or when transporting;

Turn the control knob to "OFF" position.

Disconnect LP Cylinder and move to a secure, well-ventilated area out of the reach of children and stored outdoors.

Do NOT store in a location that will exceed 125 degrees F.

Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).

If desired, cover heater to protect ecterior surfaces and to help prevent build up in air passages.

CLEANING :

1.Remove the reflector and emitter by removing the 4 pcs screws ( 1 ) that fasten the emitter to the lower screen cone .

Any debris in the burner port should be cleared. Any rust can be removed carefully with a wire brush. Never use a piece of wood, or other materials that might break off and block the ports.

2.Remove lower cone cylinder by removing the 4 pcs screws ( 2 ) which attach the lower cone cylinder to the control cylinder. Clear debris on the surface of thermocouple.

3.Remove the 4 pcs screws ( 3 ) at the bottom of control cylinder. Clear the debris of the surface and the inside of the injection nozzle.

NOTE :

It is recommended that this heater painted body components from the emitter down are periodically protected with a coat of automobile wax. If repainting is necessary, paint only the post and gas cylinder housing. Never paint the reflector, combustion assembly, or instruction plate on post.

Keep exterior surfaces clean:

Use warm soapy water for cleaning. Never use flammable of corrosive cleaning agents.

While washing your unit, be sure to keep the area around the combustion assembly dry at all times. If the gas control is exposed to water in any way, do NOT try to use it. It must be replaced.

STORAGE/CLEANING

WARNING

FOR YOUR SAFETY :

DO NOT touch or move heater for at least 45 minutes after use.

Allow all burner elements to cool before touching.

NOTE

In a salt-air environment (such as near an ocean). corrosion occurs more quickly than normal. Frequently check for corroded areas and repair them promptly.

NOTE

Wait until heater is cool before covering.

1	Emitter
	Screen

Lower

Cone

Cylinder

2

Control

Cylinder

3

13