MTD 795, 792, 791, 790 manual Attaching the Battery Cables, Gas and Oil Fill-up, Tire Pressure

Page 9

Attaching the Battery Cables

NOTE: Some models are shipped with the battery cables already connected.

IMPORTANT: The positive battery terminal is marked Pos. (+). The negative battery terminal is marked Neg. (–).

The positive cable (heavy red wire) is secured to the positive battery terminal (+) with a hex bolt and hex nut at the factory. Make certain that the rubber boot covers the terminal to help protect it from corrosion.

Remove the hex bolt and hex nut from the negative cable.

Remove the black plastic cover, if present, from the negative battery terminal and attach the negative cable (heavy black wire) to the negative battery terminal (–) with the bolt and hex nut.

Make certain the hold-down rod is in position over the battery, securing it in place. See Figure 3.

Rubber

Boot

Hold Down Rod

Hex Nut

Hex Bolt

Figure 3

NOTE: If the battery is put into service after the date shown on top of battery, charge the battery as instructed on page 26 of this manual prior to operating the tractor.

Gas and Oil Fill-up

The gasoline tank is located under the hood and has a capacity of 1-1/2 gallons. Do not overfill.

WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes, and other sources of ignition.

Service the engine with gasoline and oil as instructed in the separate engine manufacturer’s Operator/Owner Manual packed with your tractor. Read instructions carefully.

Tire Pressure

WARNING: Maximum tire pressure under any circumstances is 30 psi. Equal tire pressure should be maintained at all times.

The tires on your unit may be over-inflated for shipping purposes. Reduce the tire pressure before operating the tractor. Recommended operating tire pressure is approximately 10 p.s.i for the rear tires & 14 p.s.i. for the front tires. Check sidewall of tire for maximum p.s.i.

9

Image 9
Contents MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio Operator’s ManualTable of Contents General Operation Important Safe Operation PracticesSlope Operation Towing Page — Slope GaugeTractor SET-UP Tools Required For AssemblyLoose Parts Attaching The Steering WheelAttaching the Battery Cables Gas and Oil Fill-upTire Pressure Quick Adjustment Seat Standard Adjustment SeatKnob Adjustment Seat Attaching The SeatKnow Your Lawn Tractor Parking Brake Lever Throttle Control LeverChoke Control Brake PedalIgnition Switch Ignition Switch Module if equippedSpeed Control Lever Operating Your Lawn Tractor Safety Interlock SwitchesEngaging the Parking Brake Setting the Cutting HeightStarting the Engine Stopping the EngineDriving On Slopes Using the Deck Lift LeverEngaging the Blades MowingMulching if equipped Moving The Tractor ManuallyHeadlights Making AdjustmentsLeveling the Deck Front To RearSide to Side Leveling the Deck con’tQuick Adjustment Seat if so equipped Standard Adjustment SeatDrag Link Adjustment Parking Brake AdjustmentMaintaining Your Lawn Tractor EngineLubrication Deck Wash System Cleaning the Engine And DeckCutting Deck Removal ServiceTires Changing the Transmission BeltInch Deck Battery FuseCutting Blades Changing the Deck Belt OFF-SEASON Storage Attachments & AccessoriesPage Page MANUFACTURER’S Warranty Coverage MANUFACTURER’S Limited Warranty for