MTD 769-01445 manual Unpacking Instructions, Assembling Your Lawn Mower

Page 7

SECTION 3: UNPACKING INSTRUCTIONS

Remove Unit From Carton

NOTE: Reference to the right or left hand side of the mower is observed from the operating position.

Remove staples, break glue on the top flaps, or cut the tape at carton end and peel along top flap to open the carton.

Remove any loose parts included with the unit (i.e., operator’s manual, etc.).

Cut the corners and lay the carton down flat.

Remove packing material.

Roll or slide the unit out of carton. Check the carton thoroughly for loose parts.

REMOVE MANUAL & LOOSE PARTS

PUSH

Figure 1

SECTION 4: ASSEMBLING YOUR LAWN MOWER

Loose Parts in Carton

Grass Catcher Assembly. Refer to Figure 2.

Owner’s Manual (not shown).

Rear Frame

Front Frame

Grass Bag

Figure 2

Tools Required

A pair of pliers.

Assembling Handle

Remove any packing material which may be between the upper and lower handles for shipping purposes.

Pull up and back on the upper handle to raise the handle into the operating position. Make certain the lower handle is seated securely into the handle mounting brackets. Refer to the steps in Figure 3.

32

1

Figure 3

WARNING: The handle insulators are not only used to adjust handle height, but are also a safety device and should never be altered in any way. If replacement is necessary, use original equipment parts as shown in the parts list on page 17.

The upper handle may be adjusted to three different height positions. To adjust the handle at the desired position, align one of the three marks on the top of the lower handle insulators with the mark on the upper handle insulators. See Figure 4.

Tighten the hand knobs on each side of the handle. Make sure that carriage bolts are seated properly into the handle insulators.

7

Image 7
Contents OPERATOR’S Manual Finding Model Number Table of ContentsCalling Customer Support General Operation Important Safe Operation PracticesChildren Slope OperationDouble Insulated Lawn Mower ServiceSlope Gauge Assembling Your Lawn Mower Unpacking InstructionsAttaching The Grass Catcher Assembling the Grass CatcherCircuit Breaker Motor/Blade Control AssemblyKnow Your Lawn Mower Rear Trailing ShieldCord Connection Height Adjustment LeverOperating Your Lawn Mower Cord RestraintMowing Your Lawn Stopping the Motor and BladeMaintenance Making AdjustmentsLubrication Mower DeckOFF-SEASON Storage Trouble Possible Causes Corrective Action Trouble Shooting GuideParts LIST/LISTE DES Pièces Part RÉF Pièce Description TWO Year Limited Warranty Safety and Decorative LABELS/ Étiquettes Vente Après Service ET Garantie Sous Pièces 11 Section Tonte Capot le Inadéquat Dépannage 10 SectionLubrification Saison Hors Entreposage 9 SectionEntretien 8 Section Lame la de RemplacementDisjoncteur du Réenclenchement Guidon du hauteur la de RéglagePelouse la de Tonte Rallonge d’une choix Le Utilisation 6 SectionFamiliarisation 5 Section Herbe à sac du Assemblage Herbe à sac du InstallationDétachées Pièces Tondeuse la de DéballageDéballer Pour Instructions 3 Section Guidon du AssemblageTRE Pour DÉ Terminer LES Pentes SUR Lesquelles IL Serait Terrain DU Pente LA DE Calcul 2 SectionGarde EN Mise DE Étiquettes Entretien Double Isolation’enfants présence en Utilisation Risques des présentant Utilisation Courante Utilisation Sécurité DE Consignes 1 SectionMatières DES Table Modèle DE Numéro’UTILISATION Notice