6
Trouble
Shooting
For repairs beyond the minor adjust- ments listed here, contact an autho- rized service dealer.
Problem |
| Cause |
| Remedy |
|
|
|
|
|
Engine fails to start | 1. | Blade control handle disengaged. | 1. | Engage blade control handle. |
| 2. | Spark plug wire disconnected. | 2. | Connect wire to spark plug. |
| 3. | Fuel tank empty or stale fuel. | 3. | Fill tank with clean, fresh gasoline. |
| 4. | Engine not primed. | 4. | Refer to engine manual. |
| 5. | Faulty spark plug. | 5. | Clean, adjust gap, or replace. |
| 6. | Blocked fuel line. | 6. | Clean fuel line. |
| 7. | Engine flooding. | 7. | Wait a few minutes to restart, but do not |
|
|
|
| prime. |
|
|
|
|
|
Engine runs erratic | 1. | Spark plug wire loose. | 1. | Connect and tighten spark |
|
|
|
| plug wire. |
| 2. | Blocked fuel line or stale fuel. | 2. | Clean fuel line; fill tank with clean, fresh |
|
|
|
| gasoline. |
| 3. | Gas cap vent plugged. | 3. | Clear vent. |
| 4. | Water or dirt in fuel system. | 4. | Drain fuel tank and carburetor. Refill with |
|
|
|
| fresh fuel. |
| 5. | Dirty air cleaner. | 5. | Refer to engine manual. |
| 6. | Carburetor out of adjustment. | 6. | Refer to engine manual. |
|
|
|
|
|
Engine overheats | 1. | Engine oil level low. | 1. | Fill crankcase with proper oil. |
| 2. | Dirty air filter. | 2. | Refer to the engine manual packed with |
|
|
|
| your unit. |
| 3. | Air flow restricted. | 3. | Remove blower housing and clean. |
| 4. | Carburetor not adjusted properly. | 4. | Refer to engine manual. |
|
|
|
|
|
Occasional skip | 1. | Spark plug gap too close. | 1. | Adjust gap to .030”. Refer to engine |
(hesitates) at high speed |
|
|
| manual. |
| 2. | Carburetor idle mixture adjustment | 2. | Refer to engine manual. |
|
| improperly set. |
|
|
|
|
|
|
|
Idles poorly | 1. | Spark plug fouled, faulty or gap too | 1. | Reset gap to .030” or replace spark plug. |
|
| wide. |
| Refer to engine manual. |
| 2. | Carburetor improperly adjusted. | 2. | Refer to engine manual. |
| 3. | Dirty air cleaner. | 3. | Refer to engine manual. |
|
|
|
|
|
Excessive vibration | 1. | Cutting Blade loose or unbalanced. | 1. | Tighten blade and adapter. Balance blade |
| 2. | Bent cutting blade. | 2. | Replace blade. |
|
|
|
|
|
Mower will not mulch | 1. | Wet grass. | 1. | Do not mow when grass is wet; |
grass |
|
|
| wait until later to cut. |
| 2. | Excessive high grass. | 2. | Mow once at a high cutting height, then |
|
|
|
| mow again at desired height or make a |
|
|
|
| narrower cutting path. |
| 3. | Dull blade. | 3. | Sharpen or replace blade. |
|
|
|
|
|
Uneven cut | 1. | Wheels not positioned correctly. | 1. | Place all four wheels in same height |
|
|
|
| position. |
| 2. | Dull blade. | 2. | Sharpen or replace blade. |
|
|
|
|
|
12