Marantz manual How to operate function and how to set up, If using more than 1 SC-7S1

7. How to operate function and how to set up

If using more than 1 SC-7S1

Set up the ID numbers to the respective SC-7S1s to identify each of the SC-7S1s.

Set up the ID No. switch <1> for the main unit of the SC- 7S1 to control others, which is called <Master> unit.

The ID No. set up will be indicated in the display window for 3 seconds when the unit is powered on.

stereo control amplifier sc - 7s1

A SYNC B

power

Light Green

Set up the other SC-7S1s <2>–<6> which will be controlled by the Master.

They are called <Slave> units.

The ID No. set up will be indicated in the display window for 3 seconds when the unit is powered on.

stereo control amplifier sc - 7s1

ID NO.

1

2

3

4

5

6 A SYNC B

MODE

Light RED

The Trim adjustment set by the Master, will be the same for all Slave SC-7S1s.

Once the set up for the Trim has been finished, press the Trim mode button on the Remote control.

The trim adjustment will move from Master to Slave. Then the indicator on the Front display of the Slave will illu- minate Red, the Sync indicator will flash Red.

stereo control amplifier sc - 7s1

A SYNC B

Light Red Flash Red

Please refer to p.17 for Trim adjustment .

If the whole system consist of more than 3 units, please repeat the same procedure and set up the remaining units.

Make sure to change the ID # in the SC-7S1 to match the ID # of the amplifier being adjusted.

Once you have completed the trim adjustment, press the Exit button on the remote control. This concludes the ad- justments and memorizes them.

18