To Replace Belt Step, To Adjust Belt | King Kutter Free Floating

TO REPLACE BELT:

STEP 1	Remove top cover.
STEP 2	Release adjustment spring.
STEP 3	Loosen nut on adjustment pulley to allow for movement. (See Fig-
	ure “D”)
STEP 4	Loosen nut on right side of “L” bracket. (See Figure “D”)
STEP 5	Loosen belt by moving adjustment pulley in opposite direction you
	would to tighten belt.
STEP 6	Remove nuts (2) from hinged gearbox plate from finishing mower
	deck. (See Figure E)
STEP 7	Loosen nuts (2) from hinged bolt gearbox plate.
STEP 8	Raise gearbox assembly and slip out belt.
STEP 9	See Figure D for belt placement on pulleys.
STEP 10	Do step 5 thru 7 under Section: "TO ADJUST BELT" to tighten.
TO ADJUST BELT:
STEP 1	Remove top cover.
STEP 2	Release adjustment spring.
STEP 3	Loosen nut on adjustment pulley to allow for movement. (See Fig-
	ure D )
STEP 4	Loosen nut on right side of “L” bracket. (See Figure D)
STEP 5	Turn nut on left side of “L” bracket in counter clockwise direction
	until belt is tight.
STEP 6	Re-tighten nut on right side of “L” bracket and nut on adjustment
	pulley.
STEP 7	Re-hook adjustment spring. (See Figure “D”)
22