Using Your Snugasabug® Tie-Down Electric Blanket
Before First Use
Remove any promotional material and packaging from the electric blanket.
Repeat procedure for the tape at the top end of the mattress. The electric blanket should now be firmly taped to the mattress as shown in Fig 3.
Securing Your Tie-Down Electric Blanket
Place the electric blanket on the mattress towards the foot of the bed. Leave sufficient room for the pillow and ensure the control leads are near the head of the bed. Remove tags from tie tapes. Pass the middle tie tape under the middle of the mattress and through the middle loop on the opposite side. Tie tightly.
Fig. 1
Pass end tape under the bottom corner of the mattress and through the end loop, then down under the opposite bottom corner of the mattress and through the bottom side loop. Tie tape firmly.
Fig. 2
Fig. 3
To Connect The Controller
Your blanket has a detachable controller and waterproof element which makes your blanket machine washable.
Ensure the electric blanket controller is in the ‘OFF’ position and not connected to the 230V or 240V power supply.
To connect your controller, thread the detachable plug from the controller and plug it fully into the socket.
Ensure that the locking clip engages with the small plastic pin on the plug.
Turn the electric blanket over, position and fit it to the mattress.
To Detach The Controller
The socket has a locking clip that engages with a small pin on the plug. With the controller set to the ‘OFF’ position indicated by a ‘0’ and power plug removed from the 230V or 240V power supply, push the clip out to release the socket pin and withdraw the connector plug by pulling it away from the socket.
7
KEB302_IB_FA.indd 7 | 12/10/09 10:13 AM |