Jonsered GT2125L manual Assembling other guards and cutting equipment GR2126L

ASSEMBLY

Assembling the spray guard and trimmer head Auto 32 (GR2126L)

Assembling other guards and cutting equipment (GR2126L)

•Fit the guard (A) intended

for use with the trimmer head. Hook the guard onto the shaft fitting and secure it with the bolt (L).

•Fit the drive disc (B) on the output axle.

•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.

•Insert the locking pin (C) in the hole so that the axle is locked.

•The trimmer head must be

split to be fitted (see the		K
diagram). Proceed as		J
follows:
		I
• Insert your finger into the
centre hole of the cover (I)
at the same time as you		K
hold the cover with your
other fingers. Press the two
catches (J) that extend from
the cut-out on the bottom	G
section (K) using the	F	B
thumb and index finger of	I
		C
your other hand. Press
apart the trimmer head
using the fingers on the
cover.

•Fit the guard (A) intended for use with the trimmer head. Hook the guard onto the shaft fitting and secure it with the bolt (L).

•Fit the disc drive (B) on the output axle.

•Turn the blade axle until one of the disc drive’s holes aligns with the corresponding hole in the gear housing.

•Insert the locking pin

(C) into the hole to lock the axle.

•Screw on the trimmer head (H) in the direction of rotation.

•Dismantling takes place in the reverse order.

H

• Place the cover (I) and the
support flange (F) on the	A
output axle.

•Fit the nut (G). The

tightening torque of the nut is 35-50 Nm (3,5-5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the trimmer guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread).

•Fit the trimmer head‘s bottom section (K) on the cover (I) by pressing the

two sections together with

the cut-outs on the bottom section aligned with the catches on the cover.

•To dismantle follow the instructions in the reverse order.

Fitting the spray guard and trimmer head (GT2125L)

Guard

• Fit the guard as shown in the diagram. Tighten securely.

Trimmer head

• Fit the dust cup on the shaft. The nut must be completely covered by the dust cup.

•Hold the dust cup with

a spanner to prevent the shaft from rotating.

• Screw the trimmer head onto the shaft.

English – 13