Jacuzzi EC30000, EC31000, EC33000 manual 250 mm

4.Using the dimensions indicated in Figure 9, drill two holes 1/4” diameter by 1-3/8” deep into the wall on the right hand side of the shower tower. Insert the plastic anchors (18) into each of the holes, and mount the bracket (17) onto the wall using the M3.5x25mm Screws (19).

Figure 9 9-7/8"

(250 mm)

	19	17	18
	2"
	(23 mm)
2 HOLES
1/4" DIA. (6,4 mm) x
1-3/8 " (35 mm)
DEEP	63"
	(1600 mm)	2 HOLES
		1/4" DIA. (6,4 mm) x
		1-3/8 " (35 mm)
	TO FLOOR		DEEP

5.Confirm the sealing washer (21) is inside the end of the S.S. flexible hose (16). Attach the hand shower (15) onto the hose by hand and place the hand shower into the bracket as shown in Figure 10.

6.After finishing the installation, the shower tower is ready for use.

7.There is an optional tube-shaped temperature check spout (13) as an alternative to the pre-installed square- shaped temperature check spout (12). To exchange these two components, use a hand wrench (not sup- plied) to remove the supply hose connecting nut attached to the square-shaped temperature check spout. Remove the mounting nut of the spout to release it. After that, install the tube-shaped temperature check spout into the mounting hole and tighten it, and mount it with the supplying hose, see Figure 11.

NOTE: To avoid scratching the front surface, do not turn square spout. Hold and remove washer rather than remove the square spout.

Figure 11

15

Figure 10

21 13

16

12

Jacuzzi Whirlpool Bath: Shower Towers Page 13 FZ71000B • 09/07