Homelite UT08542A General Maintenance, Lubrication, Replacing and Cleaning the AIR Filter

Page 16

MAINTENANCE

WARNING:

When servicing, use only identical Homelite replacement parts. Use of any other parts may create a hazard or cause product damage.

WARNING:

Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrication

REPLACING AND CLEANING THE AIR FILTER

See Figure 14.

For proper performance and long life, keep air filter clean.

nPush down on the latch of the air filter cover; carefully pull the top of the air filter cover so it pivots away from the base.

nRemove the air filter and clean it in warm soapy water. Rinse and let dry completely.

nReinstall the air filter into the air filter base.

nPivot the cover back in place. Push the latch back into the slot and ensure the cover is locked in place.

NOTE: For best performance, the air filter should be replaced annually

AIR FILTER

BASE

 

LATCH

AIR FILTER

is required.

COVER

16

Fig. 14

Image 16
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Specific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Product Specifications FeaturesUpper Handle High Velocity Nozzle Know Your Blower Blower Tube and NozzleCruise Control / Throttle Lock High Velocity NozzleUnpacking AssemblyPacking List Installing the Vacuum BAG Assembling the Blower TubesSee Figure See Figures 4Installing the Vacuum Tubes See Figures 6Operation Mixing the FuelFilling the Tank Premium Exact MIXOperating the Blower Starting and StoppingSee Figures 10 Cruise Control Throttle Lock Vacuum OperationTo Engage the Cruise Control Wide Sweeper Nozzle High Velocity Cruise ControlOperation Maintenance General MaintenanceReplacing and Cleaning the AIR Filter LubricationAccessories Troubleshooting Warranty Limited Warranty StatementMANUFACTURER’S Warranty Coverage Emissions Maintenance Schedule and Warranted Parts List AIR Filter AssyCarburetor Assy Fuel Tank AssyCalifornia Proposition Model Number