Homelite HG5700 Assembly, Installing the wheels, Securing the handle, See Figures 4, English

assembly

installing the wheels

See Figure 3.

Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the handle.

Locate the following items:

2 bolts (3/8-16 x 4-1/4 in.)

6 washers (3/8 in.)

2 spacers (.38 ID)

2 wheels

2 lock nuts (3/8-16)

Raise the end of the generator opposite the handle high enough to gain access to the frame bottom; securely position props underneath to support.

Insert a wheel spacer into the center of the wheel.

Place a washer on the bolt, then slide bolt through the wheel.

Thread another washer on the bolt, then slide the bolt through the U-bracket frame on generator.

Place a washer on end of bolt.

Install nut on bolt and tighten securely.

Repeat the process on the other side to install second wheel.

securing the handle

See Figures 4 - 5.

Locate the following items: Handle lock pin Lanyard

Attach the lanyard to the handle lock pin and the handle as shown in figure 4.

Insert the pin through the hole in the handle and the generator frame to secure handle in place.

warning:

Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury.

lock u-bracket nut

washer

lanyard

handle

lock pin

frame

handle hole lock pin

wheel

wheel

spacer

bolt

washer Fig. 3

frame

Fig. 4

handle

Fig. 5

Page 14 — English