Specifications, Others, Repairs | Marantz SW7001 instruction

ENGLISH

SPECIFICATIONS

¶Power amplifier section

Rated output	50 W (EIAJ 100 Hz, 4 Ω)
Line input sensitivity	...........................	220mV
Frequency characteristics		38Hz–170Hz

¶ Speakers

Enclosure	bass reflex type
Speaker unit	16 cm cone
Rated impedance	4 Ω

¶ Power supply

Power requirements	AC 120 V 60 Hz
Rated power consumption	60 W

Power consumption in standby mode... 0.5 W

¶Dimensions / Mass

Width	231 mm (9-1/8 ins.)
Height	203 mm (8 ins.)
Depth	312 mm (12-5/16 ins.)
Mass	6.2 kg (13.7 lbs)
¶ Supplied accessories
Audio cable		1
Remote control cable		1
User Guide (this manual)		1
Warranty card (USA x 1, CANADA x 1)		1
Note:
The speaker nets cannot be removed.

OTHERS

The section describes the care and maintenance tasks that must be performed to optimize the operation of your Marantz component.

7Cleaning of equipment external surfaces

The exterior finish of your unit will last indefinitely with proper care and cleaning, Never use scouring pads, steel wool, scourging powders or harsh chemical agents (e.g., lye solution), alcohol, thinner, benzine, insecticide or other volatile substances as these wil mar the finish of the equipment. Likewise, never use cloths containing chemical substances.

7Repairs

Only the most competent and qualified service technicians should be allowed to service the factory-trained warranty station personnel have the knowledge and special facilities needed for repair and calibration of this precision equipment. After the warranty period has expired, repairs will be performed for a charge if the equipment can be returned to normal operation.

In the event of difficulty, refer to your dealer or write directly to the nearest location to you that is listed on the Marantz Authorized Service Station list. If writing, please include the model and serial number of the equipment together

¶Dimensions

	3	312 (12-5/16)	7
231 (9-1/8)	3		7
231 (9-1/8)	(1/8)	302 (11-15/16)	(5/16)
201 (7-15/16)	203 (8)
2 (1/8)

Unit: mm (inch)

Specifications subject to change without prior notice.

If the equipment get dirty, wipe the external surfaces with a soft, lint-free cloth.

If the equipment becomes heavily soiled:

•dilute some washing up liquid in water, in a ratio of one part detergent to six parts water.

•dip a soft, lint free in the solution and wring the it is damp.

•wipe the equipment with the damp cloth.

•dry the equipment by wiping it with a dry cloth.

with a full description of what you think is abnormal about the equipment’s behaviour.