Harbor Freight Tools 93815 manual Please Read the Following Carefully, HOW to Free a Jammed LOG

Page 13

Warning: Be sure to dispose of the dirty oil properly.Take it to your local waste oil recycling center. Never dump it on the ground or mix it with trash.

Refilling the Hydraulic Oil

1.Periodically check the level of the oil. It must be between the two notches on the lower end of the Dip Stick. If the oil level is low, refill using a recommended oil.

Sharpening the Wedge

1.After long periods of operation, and when required; sharpen the wedge using a fine-toothed file and carefully removing any burrs or flat spots on the edge.

HOW TO FREE A JAMMED LOG

1.Release both controls, so that the LOG PUSHER (49A) will be fully retracted.

2.Insert a triangular wedge of wood under the log, and activate the log pusher to push the wedge under the jammed log.

3.Repeat this process using progressively larger wedges, until the jammed log is freed. Warning: Never hammer on the jammed log, or place your hands near the log when attempting to free it.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTUER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 93815

PAGE 13

Image 13
Contents LOG Splitter General Safety Rules Product SpecificationsSave this Manual Work AreaPersonal Safety Electrical SafetyTool USE and Care Service Specific Safety RulesSKU Grounded Tools Tools with Three Prong Plugs GroundingDouble Insulated Tools Tools with TWO Prong Plugs Extension CordsFigure C SymbologyUnpacking AssemblyAllow the Log Pusher 49A to retract Operating InstructionsMaintenance INSPECTION, MAINTENANCE, and CleaningPlease Read the Following Carefully HOW to Free a Jammed LOGParts List Assembly Diagram Warranty Limited 90 DAY Warranty