Harbor Freight Tools 95091 manual See Figure G

4. CAUTION! Make sure the Chipper/Shredder is empty of material prior to starting the unit.

5.Check to make sure the Wing Nut (36) is securely tightened. (See Figure G.)

6.Check to make sure the Power Switch (42) is in its “OFF” position. Then plug the Power Cord of the unit into the nearest 120 volt, grounded, electrical outlet.

(See Figure G.)

7.NOTE: The Power Switch (42) features a Safety Key to prohibit unauthorized people from turning on the Chipper/Shredder. To use this feature, turn the Power Switch to its “OFF” position. Then, remove the Safety Key from the Power Switch and store the Safety Key in a safe location. The Safety Key must be reinserted in the Power Switch to turn on the Chipper/Shredder.

(See Figure G.)

8.Insert the Safety Key into the Power Switch (42). Then turn the Power Switch to its “ON” position to start the Chipper/Shredder. (See Figure G.)

9.Allow sufficient time for the Chipper/Shredder to run at full speed before feeding material into the Hopper (1) of the unit.

10.IMPORTANT: Do not force the Chipper/Shredder. Branches cannot be more than 1-1/4”in diameter for the Chipper/Shredder. Do not attempt to force larger branches into the Hopper (1). Let the natural suction process take in the material to be cut. (See Figure G.)

HOPPER

(1)

WING NUT

(36)

OVERLOAD PROTECTOR

(45)

POWER SWITCH WITH SAFETY KEY

(42)

DISCHARGE CHUTE

POWER CORD

FIGURE G

SKU 95091 For technical questions, please call 1-800-444-3353 PAGE 12