Global Machinery Company GEN800 Fitting the handle, Mixing the fuel, Filling the fuel tank

Page 11

Fitting the handle

Firstly, place the 2 handle gaskets (supplied with the generator) over the holes on the petrol tank. Then proceed by placing the handle on top of the gaskets ensuring the 2 holes in the handles line up with the holes on the tank.

Screw the handle onto the petrol tank using the 2 screws provided with the unit. Ensure the flat washers and spring washers are fitted under the heads of the screws.

Mixing the fuel

1.The generator uses unleaded fuel and 2 stroke grade oil.

2.You need to mix both unleaded fuel and 2 stroke oil together.

3.The proportion should be 40 parts unleaded fuel and 1 part 2 stroke oil.

Quick reference/common fuel mixture requirements for 40:1 is:

-1 Litre of unleaded fuel mixed with 25mL of 2 stroke oil.

-5 Litres of unleaded fuel mixed with 125mL of 2 stroke oil.

4.The mixture should be poured into an approved fuel container. This fuel container should be clearly marked as a fuel container, sealed and made from fuel resistant material.

5.Once the mixture has been poured, shake the fuel container well to ensure that the contents have been thoroughly mixed.

Filling the fuel tank

1.Switch off the engine.

2.Remove the fuel cap (2) by turning anticlockwise.

3.Pour the fuel/oil mix from the fuel container into the fuel tank (3). Because fuel expands, DO NOT FILL to the tip of the tank.

4.Replace fuel cap and turn clockwise to lock.

Starting the engine

1.Before starting, ensure that no electrical apparatus has been connected to the generator.

2.Turn the fuel tap (4) clockwise to the ‘on’ position.

3. Move the choke lever to the left hand side position.

4.Press “I” on the on/off rocker switch.

5.Slowly pull the recoil starter until you feel it engage and then pull it briskly.

Note: When the engine is started for the very first time, it will require a number of attempts to start until the fuel has travelled from the tank to the engine.

11

Image 11
Contents 800W Generator Contents Environmental protection Description of symbolsSpecifications IntroductionGeneral safety instructions for power tools Placing generator on or against Hazard What could happen How to prevent itOperation of generator in rain, wet Icy, or flooded conditionsRisk of fire Carbon monoxide exhaust fumes Risk of breathing inhalation hazardRisk of unsafe operation To Vehicle SurfacesRisk from lifting Risk of hot surfacesRisk of moving parts Ensure you use oil-mix fuel. Ensure that you mix Additional safety rules for generatorsUnpacking Know your product Starting the engine Fitting the handleMixing the fuel Filling the fuel tankStopping the engine Connecting apparatus to the generator ACConnecting apparatus to the generator DC Storage Periodic maintenanceGenerator maintenance AC and DC overload cut outTap extension fuel filter Air filterRepairs CleaningPetrol tank filter Troubleshooting Page Page Page GMC customer assist