6.Once you hear the engine operating, return the choke lever back to the right hand side position. This position will switch the choke ‘off’.
Stopping the engine
1.Before stopping, ensure that no electrical apparatus is connected to the generator.
2.Turn the engine switch to the ‘stop’ position.
3. Turn the fuel tap (4) anti- clockwise to the ‘off’ position.
Connecting apparatus to the generator
1.Start the engine. Allow the engine to run for a couple of minutes to warm up prior to connecting any apparatus to the generator. The green power on light (12) will illuminate when the generator is operational and power is available at the socket.
2.For AC current, plug the power cord into the AC output socket (10).
WARNING. Prior to connecting any product to the generator, check the rating label of the product. The generator is rated at 650W so if the product being connected is higher than 650W, the protective cut out on the generator may operate to prevent over load damage to the generator. The generator will withstand short operation and spikes up to 750W.
It should also be very clearly understood that output voltage fluctuations will occur when various loads are connected and disconnected. It is best to always use a voltage or surge protector with this generator. It is NOT recommended to connect any electronic equipment to the generator such as computers, televisions, or stereo equipment. They are very sensitive to the input supply fluctuations and could be damaged if run off this generator. This warning also includes caravans where electronic equipment is incorporated as part of the wiring.
AC overload cut out
IMPORTANT: Exceeding the rated capacity of your generator can result in serious damage to your generator and connected apparatus.
1.Each receptacle has a circuit breaker to protect the generator from over loading.
2.If the circuit breaker trips, unplug all electrical apparatus from the generator.
3.Let the overload cut out switch cool down.
4.If it is an AC apparatus causing the overload push the AC circuit breaker button (11). Commence to start your generator accordingly.
5.When re connecting appliances, reduce the load to that which previously overloaded the generator.
12