Unpacking

Due to modern mass production techniques, it is unlikely that your power tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.

Fitting the collection bag

1. Connect the strap (fig A)
1. Connect the strap (fig A)
onto the hook on the	B
underside of the blower	B
vacuum housing (fig B).

2.Attach the push-on plastic connector (fig C) to the outlet tube of the housing

	(fig D). Push the fitting	A
	of the collection bag
	directly onto the outlet
	until it “clicks”
	into position (fig E).
	3. To remove the collection
	bag, disconnect the	D
	attachments in the	D
	reverse order.	C
	4. When removing the	C
	4. When removing the
	fitting on the outlet,
	first depress the two
	first depress the two
	buttons on either side
	buttons on either side
	of the plastic connector	E
	(fig F), and then pull	E
	downwards on the fitting.
	Finally, remove the strap	F
	from the hook under the	F
	from the hook under the
	blow/vacuum tube.

Operation of the blower vac

Prior to using the blower vac, ensure you have read and understood this instruction manual.

•Ensure you are wearing suitable clothing and also safety equipment like safety glasses, ear protection and a mask if necessary.

•Ensure the attachments to the blower vac are correctly fitted and adjusted.

•Be aware of other people and animals in the area where you are to be operating the blower vac.

To turn the blower vac on

1. Plug the power cord into	G
1. Plug the power cord into
an approved electrical
extension cord, and turn
the extension cord on.

2.Ensuring the blower vac is directed in a safe direction, depress the trigger switch

(1) and the blower vac will start. (fig G).

Be sure to be holding the blower vac firmly on start up.

To turn the blower vac off

To turn the blower vac “off”, simply release the trigger switch.

Important. After you have turned the blower vac off, do not leave the product until the blower vac has been fully disconnected from the electrical supply.

To select the blow operation

1. Move the blower/vacuum selector lever (2) towards H the back of the housing

(fig H).

When the blow operation is selected, air is drawn up through the large blow/vac tube and then expelled at a much higher velocity in the