Extension cord support
During use of the blower vac, the extension cord will continually be pulled as you move from one area to another.
An extension cord support has been provided on the housing of the blower vac to assist in preventing the electrical connection between the extension cord and blower vac plug being forced apart.
Note. The support is for the extension cord, and not the cable from the blower vac.
1. To fit the extension cord to the support, make a tight loop in the extension cord, approximately 300mm from the socket on the extension cord.
2. Fit the loop into the
square recess in the back A portion of the blower vac
on the underside of the housing (fig A).
3.Push the loop all the way through the housing by approximately 25mm.
4.Push each side of the loop downwards so each side of
the loop fits over the hook | B |
inside the recess (fig B). |
|
5.After, and only after the cable is correctly seated, plug the blower vac plug into the socket of the extension cable.
Operation of the blower vac
Prior to using the blower vac, ensure you have read and understood this instruction manual.
Ensure you are wearing suitable clothing and also safety equipment like safety glasses, ear protection and a mask if necessary.
Ensure the attachments to the blower vac are correctly fitted and adjusted.
Be aware of other people and animals in the area where you are to be operating the blower vac.
To turn the blower vac on
1.Plug the power cord into an approved electrical extension cord, and turn the extension cord on.
2.Ensuring the blower vac is directed in a safe direction, A
push the
While holding the trigger switch the blower vac will continue to operate without the need to hold the
To turn the blower vac off
To turn the blower vac “off”, simply release the trigger switch.
Important. After you have turned the blower vac off, do not leave the product until the blower vac has been fully disconnected from the electrical supply.
9