Generac Power Systems 5418 Home Standby Transfer Switch Ordered Separately, Generator, Engine

Home Standby – 18kW

GENERATOR		Model 05418 - Aluminum
Rated Maximum Continuous Power Capacity (LP)		18,000 Watts*
Rated Maximum Continuous Power Capacity (NG)		16,000 Watts*
Rated Voltage		120/240
Rated Maximum Continuous Load Current
240 Volts		75.0 LP/66.6 NG
Main Line Circuit Breaker		80 Amp
Phase		1
Number of Rotor Poles		2
Rated AC Frequency		60Hz
Power Factor		1
Battery Requirement (not included)	Group 26, 12 Volt Negative Ground and 525 Cold-cranking Amperes Minimum
Unit Weight		451 Pounds
Dimensions (L” x W” x H”)		48 x 24 x 28-1/4
Sound output in dB(A) at 23 ft. with generator at normal operating load		66
Sound output in dB(A) at 23 ft. with generator in Quiet-Test™ exercise mode		.................................................. 60

ENGINE	Model 05418 - Aluminum
Type of Engine	GENERAC OHVI V-TWIN
Number of Cylinders	2
Rated Horsepower	31.5 @ 3,600 rpm
Displacement	992cc
Cylinder Block	Aluminum w/Cast Iron Sleeve
Valve Arrangement	Overhead Valve
Ignition System	Solid-state w/Magneto
Governor System	Electronic
Compression Ratio	9.5:1
Starter	12Vdc
Oil Capacity Including Filter	Approx. 1.7 Qts.
Standby Operating RPM	3,600
Exercise RPM	2,400
Fuel Consumption
Natural Gas cu.ft./hr.
1/2 Load	181.3
Full Load	262
Liquid Propane ft3/hr (gal/hr)
1/2 Load	71.6 (1.97)
Full Load	103.5 (2.85)
Required fuel pressure to generator fuel inlet at all load ranges - 5 to 7 inches of water column for natural gas, 10 to 12 inches of water column for LP gas
CONTROLS
Mode Switch
-Auto	– Automatic start and stop on utility failure and return. 7 day exerciser.
	Cyclic cranking 7 seconds on, 7 seconds rest for 90 seconds maximum.
-Off	– Stops unit. Power is removed from controller.
	Battery charger will still operate.
-Manual/Test (start)	– Start with starter control, unit will stay on. If utility fails, transfer will take place.

HOME STANDBY TRANSFER SWITCH (ORDERED SEPARATELY)

Transfer Switch Rating	...........................	100/200/400 Amps
Number of Poles		2
UL Listed		Yes, UL 1008
Enclosure		NEMA 1
..............................................................................		NEMA 3R
Interrupt Rating		10,000 Amps
Maximum Switching Time		160 Milliseconds
Maximum Voltage		240 Volts
Exercise Time	Automatic 15 Minutes Each Week

Rating definitions - Standby: Applicable for supplying emergency power for the duration of the utility power outage. No overload capability is available for this rating. (All ratings in accordance with BS5514,

ISO3046 and DIN6271). Prime (Unlimited Running Time): Unit not recommended for prime power applications. Applicable for supplying electric power in lieu of commercially purchased power. Prime power is the maximum power available at variable load. A 10% overload capacity is available for 1 hour in 12 hours. (All ratings in accordance with BS5514, ISO3046, ISO8528 and DIN6271).* Maximum wattage and current are subject to and limited by such factors as fuel Btu content, ambient temperature, altitude, engine power and condition, etc. Maximum power decreases about 3.5 percent for each 1,000 feet above sea level; and also will decrease about 1 percent for each 12° C (10° F) above 15.5° C (60°F).