Fisher & Paykel 80078 dimensions Installation O P T I O N a C C E S S O R I E S, Control Panel

Page 1

CONTROL PANEL

Left Push Button

=

Light On/Off Switch

Second Push Button

= Fan On High Speed

Third Push Button

= Fan On Second Speed

Fourth Push Button

= Fan On Low Speed

Fifth Push Button

=

Fan Off

LIGHT REPLACEMENT

a)Halogen bulb 12Volt/20Watt required.

b)Switch off the power to rangehood.

c)Use a small bladed screwdriver to prise off the light cover.

d)Use a cloth to remove the bulb. Do not touch the bulb with fingers.

e)Replace with a new bulb using a cloth. Do not touch the bulb with fingers. Snap the cover back in place.

BULB

For other accessories, parts or service, please contact your local supplier (Refer to Warranty Certificate).

I N S T A L L A T I O N O P T I O N A C C E S S O R I E S

DUCTED

RECIRCULATED

UNIDUCT FLEXI DUCT KIT is recommended.

Use manufacturer Product Code.

1569 Flexi Duct Kit (150mm)

1744 Recirculation Kit

For other accessories, parts or service, please contact your local supplier or approved service agent

MAINTENANCE

Particular care should be taken with grease filter which must be periodically cleaned (at least every two months). Remove the grease filters and wash them either by hand or in the dishwasher using mild detergent. Caution: Never use products containing abrasives (e.g. scouring pads, steel wool, abrasive liquid cleaner etc.) Use lukewarm water and a mild detergent to clean stainless steel components. In high humidity and coastal environments, cleaning should be carried out more frequently.

WARNINGS

I N S T A L L A T I O N I N S T R U C T I O N

MODEL NUMBER 80078 RH900CB.

PLEASE READ THE ENTIRE INSTRUCTION BEFORE INSTALLING THE CANOPY

P R O D U C T D I M E N S I O N S

Care should be taken when removing filters in order to prevent the filter falling and causing damage to the hob top.

This appliance is not intended for use by young children or infirm persons without supervision.

Young children should be supervised to

ensure that they do not play with the appliance.

Upon installation the appliance must

be positioned so that the plug is accessible.

There should be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels.

You must

read the

details concerning the method and frequency of cleaning.

There is a

fire risk if

cleaning is not carried out in accordance with the instructions.

Do not flambé under the rangehood.

Exhaust air must not be discharged into an existing flue used for exhausting fumes from appliances burning gas or other fuels.

The recomended minimum distance between the hob surface and the lowest part of the range- hood is 600mm. This should be increased to at least 650mm if installed over a gas hob. We recommend 700mm.

Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is fulfilled.

If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer or it’s service agent, or a similarly qualified person in order to avoid a hazard.

320mm

72mm

900mm

280mm

525mm (min) to 725mm (max)

500mm

 

MANUFACTURED FOR

 

 

 

Electrical Rating:

 

 

372W (1.55A)

 

BY:

Max. at 230-240V 50Hz

RECOMMENDED UNIDUCT DUCTING

ROBINHOOD LIMITED

 

SYSTEMS FOR RANGEHOODS

6 ZELANIAN DRIVE, EAST TAMAKI

 

 

AUCKLAND, NEW ZEALAND

 

 

ISO9001 Certified

 

104835 issue B ECN 05 048

Image 1
Contents Light Replacement Installation O P T I O N a C C E S S O R I E SO D U C T D I M E N S I O N S Control PanelInstalling Ceiling Bracket Installing DuctingFinal Assembly Recirculated Ducted