Emerson CF2000BC02, CF2000AB02 Unpacking Instructions, Materials, Up to 50 ft 50-100 ft

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
Five wire connectors (supplied)	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric, Co. Substitution of parts or acces- sories not designated for use with this product by Emerson Electric, Co. could result in personal injury or property damage.

1.Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following:

a.Fan motor and housing assembly

b.One motor cover

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One switch housing cover

h.One loose parts bag containing:

1.One setscrew

2.One setscrew wrench

3.Eleven 10-32 x 5/8" oval head screws

4.Two 1” threaded studs

5.Two 1-1/4” threaded studs

6.Four knurled knobs

7.Five wire connectors

8.Two 8-32 x 3/8" screws

9.One pull chain pendant and coupling

10.One hairpin clip

11.One clevis pin

12.Four lockwashers

13.Twenty-one 10-32 x 3/8" pan head screws

14.Twenty-one flat washers

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before pro- ceeding.

NOTE: Fan blades are ordered separately and are pack- aged in separate carton.

FAN MOTOR AND

HOUSING ASSEMBLY

	HANGER BALL/
LOOSE	DOWNROD
PARTS	ASSEMBLY
BAG
	HANGER
BLADE	BRACKET
FLANGES
	MOTOR
	COVER
CEILING
COVER	SWITCH
	HOUSING
	COVER

3