Dixon KAW /968999561, RAM 50 MAG KOH/968999563, RAM MAG 50 manual Changing the Engine OIL, OIL Fill

Page 44

CARE AND MAINTENANCE

!	CAUTION	HOT oil may cause burns. Allow engine to
!		cool before draining oil.

CHANGING THE ENGINE OIL

1.The “Dapco” oil drain valve is located on the left side of the engine crankcase.

2.Place a suitable container under the drain valve hose.

3.To drain, turn hex head valve stem counter-clockwise with a 10mm wrench or socket. Open to full open (approximately 7 turns).

4.After engine is drained, tighten hex stem.

5.Change oil filter.

6.Fill with oil (see steps below).

Hex Head	—Fig. 9—
Valve Stem

NOTE: Refer to engine manufacturer’s recommendations for frequency of oil changes.

OIL FILL

1.Clean any spilled oil from engine and chassis.

2.Refill engine with type, and quantity of oil recommended by the engine manufacturer in engine literature.

NOTE: Engine oil changes on the Ram Series will require replacement of the oil filter. These filters may be available from your local Dixon Dealer.

44

Image 44

Contents Safety Instructions Operator’s Manual Page Important Read Carefully Page Table of Contents Safety Safety Alert Symbol General Operation General Operation Slope Operation Slope Operation Fire Hazards Fire Hazards CHILDREN, Bystanders and Pets Service Dixon ZTR Commercial / Residential Warranty Policy Specifications Specifications Specifications Specifications Specifications Specifications Specifications Seat Adjustment Instructions Controls Control LeversPark Brake To SET Park BrakeBlade Drive Choke and Throttle Control LeverOperation Instructions Mower Deck CUT Height Lift LeverBefore Operating Mower Starting Instructions Testing of Safety Interlock Systems Park Brake Switch TestBlade Drive Switch Test Mowing with a Mulching Attachment CUT High MOW Often Mowing with a Grass Catcher Attachment Mowing with a Grass Catcher AttachmentSide Discharge of the Clippings Grass Height and Cutting Suggestions Towing Trailers Other Attachments To Free Wheel MachineCare and Maintenance Maintenance ScheduleCutter Blade Maintenance Engine BatteryBelts Tires LubricationChanging the Engine OIL OIL FillTracking Adjustment Mower is tracking to the rightMower Deck Leveling Procedure Cleaning the Mower WarrantyPARTS/SERVICE Electrical SystemsTroubleshooting Skips in spots Check for loose belt/slow ground speed Engine AIR and OIL Filters Standard Service Parts ListBlades OWNER’S Information Date Engine TunedDixon and ZTR Are registered trademarks