BODY REMOVAL
A.
1.Disconnect throttle cable from engine.
2.Disconnect key switch wire loom from frame wire loom at front of body.
3.^Disconnect seat switch wire loom from frame wire loom. This connection is located approximately level with the back of the seat on left hand side of frame under the body.
4.Remove four control lever bolts and remove upper control levers.
5.Remove engaging handle by removing bolt and nut under handle.
6.Disconnect brake pedal from brake pedal arm by removing the two bolts.
7.Remove two acorn nuts on front floor and the two sheet metal screws in transaxle body mount. This also removes the two brake arm clips. Body will lift clear. To replace body reverse the above procedure. When reinstalling the two screws in transaxle body mount, make certain brake arm retainer clips extend downward and are parallel with body mount.
B.
1.Disconnect throttle cable from engine.
2.Disconnect two wire loom plugs, one going to engine wires and one going to switch. Plugs are located between back of transaxle mount and battery.
OMIT STEP (3) AND FOLLOW
C.
1.Disconnect throttle cable from engine.
2.Disconnect terminal running from motor terminal on switch to frame loom.
3.Disconnect seat switch plug from frame loom. This plug is located approximately even with back of seat on left hand side of frame under body.
FOLLOW