Specifications

CHASSIS:

BODY: MOWER

DECK:

BLADE DRIVE: TRANSMISSION:

ENGINE:

STARTING SYSTEM:

TIRES:

CAPACITIES:

DIMENSIONS:

NOTE:

Model ZTR 2301

The monocoque design chassis of the Model ZTR 2301 incorporates CMC laser and CNC brake processes to form the twin 12 gauge side frames and 7 gauge transmission and engine base plate.

All body parts are made of rotational molded polyethylene. Front body contains access panel for battery service. Seat tilts forward to allow/transmission service.

11 GA stamped steel construction. Single 30" cut blade.

Cut height approximately 1" to 4" via 7 position lift handle.

Mechanical; hand lever engagement.

Each rear wheel is independently driven by chain and sprockets through a friction mechanical drive.

14HP Kohler Command, 4-Cycle, Single Cylinder, Overhead Valve, Air-Cooled, Pressure Lubricated, With Oil Filter, Vertical Shaft, Aluminum Head and Block with Cast Iron Cylinder Liner.

Electric by key switch operation with safety interlocks on parking brake and blade drive.

Front	410 X 3.50X4 ribbed tread.	°
Rear	16 X 6.50 X 8 Multi Trac Tread.
Fuel - 2.0 gallons total.		. , ' ' •
Engine: 1.25 quarts oil.
Width	36" outside rear wheel measurement.	:
Height	35"" to top edge of seat.
Length	66.5" hitch tab to front bumper.
Weight	475 Ibs.

Additional information provided in service instructions underthe individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 8