Dimension One Spas Dream HP, Cove manual Warranty Service Information, Spring Time Startup

Page 22

2002 @ Home Hot Tubs

Owner’s Manual

19.Replace thermal cover and secure locking tabs. If your system is located in an area of high snowfall, you may want to take one more extra precaution to safeguard the life of your system cover. Span the cover with (2 or more) 2x4’s cut to length to reach the outside edges of your cover. Place a sheet of plywood, cut to fit each half of the cover, over the 2x4’s; this will carry the load of a heavy snow load and prevent the cover from warping or breaking. You can even tarp the system at this point for maximum protection.

Spring Time Startup

In the spring, or when your ready to start the system back up, follow these instructions.

Make sure o-rings for pumps are in place and undamaged.

Make sure all the fittings that you had to loosen are tightened.

Replace all jet fittings, pump drain plugs, hose bib drains and bleeder valves

Fill the system up, as you would normally do.

Turn the power back on.

Run the jets on high speed for about 15 minutes.

Drain the water.

Put your filter(s) back in.

Refill and treat chemically like you would during a normal water change.

Your system is equipped with automatic freeze protection. However, power outages can cause your system equipment to freeze quickly. During freezing conditions, check your system frequently to ensure proper operation. Always check your system after any power failure to ensure that it is operational. Draining and not operating your system disables this feature.

For additional information about winterizing your spa, please contact your local Authorized Dimension One Spas dealer.

Warranty Service Information

Your hot tub warranty gives you specific coverage. Be sure to read the enclosed warranty sheet carefully.

The warranty does not cover problems arising from misuse, abuse, or neglect, and it does not cover problems caused by improper installation or “perceived” problems caused by failure to read the hot tub owner’s manual. A service charge will be made if a service call is made for any of the following:

1.Equipment failure due to improper/inadequate electrical service. All systems require dedicated circuits as described in this manual. Low voltage can cause equipment failure and seriously shorten equipment life. It is the owner’s responsibility to ensure proper electrical service is available.

2.Failure of hot tub to reach desired temperature because the set temperature is not turned up high enough. Maximum thermostat setting is approximately 104° F (40° C).

3.Burned out hot tub light. Bulbs are not covered.

4.Hot tub water chemistry is the responsibility of the hot tub owner. Cloudy, dirty or chemically unbalanced water and cleaning of the hot tub filter are also the responsibility of the hot tub owner.

5.Hot tub shell or equipment damage caused by improper water maintenance. Serious damage can be caused if your hot tub water is not maintained carefully and correctly.

6.Poor jet action because the jet Selector valve is in the middle position. For full performance, turn the jet Selector valve to either the full clockwise or full counterclockwise position.

Do not block air intakes located on the front left corner underneath the hot tub (the front right corner for the Chairman II and Triad II) and under the equipment access panel. Resulting malfunctions are not covered under warranty.

18

Image 22
Contents Page 2002 @ Home Hot Tubs Important Safety Instructions 2002 @ Home Hot Tubs Important Safety Instructions To Reduce the Risk of InjuryImportant Safety Instructions CSA Safety Information Page Page Hyperthermia Do’s and Don’ts Dimension One Spas Jet System Selector Valve Cove Model Only Hot Tub FeaturesFollowing features are included on your hot tub Neck Jets Dream HP Model OnlyProgrammable Digital Control Filter Indicator LightSetpoint Indicator Light Top Side ControlJets 1 Pad and Status Light Heat Indicator LightJets 2 Pad OH Overheat Protection Flashing Temperature on the DisplayDigital Display Messages Flashing LED on the Control PanelUsing the Programmable Digital Controller Initial StartupPage Care for Your Hot Tub Filter CleaningLight Bulb Replacement Draining Your Hot TubCare for the Wood Hot Tub Cabinet Dimension One EnviroTect Skirts and Vinyl CoversCare for the Hot Tub Surface Ultralife and Granitech Granitex/Quarite PlusSpecial Cold Weather Instructions Procedure for WinterizingCare of the Hot Tub Cover Items Required for WinterizingReplace all equipment access panels onto the system Warranty Service Information Spring Time StartupGlossary of Terms Granitex /Quarite Plus DisclaimerHeating System Troubleshooting GuideElectrical System Water System 2002 @ Home Hot Tubs 2002 @ Home Hot Tubs 2002 @ Home Hot Tubs

Cove, Dream HP specifications

Dimension One Spas Dream HP and Cove series exemplify the perfect blend of luxury, performance, and innovation in the world of hot tubs and spas. These models are designed for consumers seeking a rejuvenating experience, combining advanced hydrotherapy features with elegant aesthetics.

One standout feature of the Dream HP is its Pulse Therapy system, which utilizes strategically placed jets to provide a rhythmic, soothing massage experience. The placement and power of these jets can be customized, allowing users to target specific muscle groups for enhanced relaxation. The Cove, similarly, features a unique jet arrangement that promotes a comprehensive massage experience, minimizing tension and reducing stress.

Both models are equipped with the proprietary Energy Smart technology. This innovative feature ensures optimal energy efficiency, significantly reducing operating costs while maintaining consistent water temperatures. The result is not only an eco-friendly approach to relaxation but also financial savings for the owner.

The construction quality of the Dream HP and Cove models is exceptional. Built with a robust exterior and high-quality materials, these spas are designed to withstand the elements. The durable shell, complete with a layer of UV protection, ensures that the colors remain vibrant over time while enhancing insulation for better temperature retention.

Water quality is paramount, and Dimension One Spas addresses this with their advanced water filtration system. This system helps to keep the water clear and clean, reducing the need for harsh chemicals and ensuring a safe and enjoyable soaking environment.

In terms of usability, both models feature intuitive controls that allow users to easily adjust temperature, jet strength, and lighting with just a few taps. The integrated LED lighting system adds a touch of ambiance, perfect for evening relaxation sessions. The ergonomic seating design in both models ensures comfort, accommodating a range of body types and preferences.

Furthermore, the Dream HP and Cove come equipped with premium audio system options, allowing users to enjoy their favorite music while unwinding. Connectivity features, including Bluetooth compatibility, provide the convenience of streaming music directly from personal devices.

Overall, the Dimension One Spas Dream HP and Cove series represent the pinnacle of enhanced hydrotherapy experiences, combining cutting-edge technology with unparalleled comfort and style. With features designed to provide both relaxation and enjoyment, these hot tubs truly redefine the concept of home wellness. Whether it’s for soothing muscle tension or enjoying a soothing soak, these spas meet the needs of modern consumers looking for a luxurious retreat in their own backyard.