SAFETY INFORMATION
Continued
Installation and repair should be done by a qualified service person. The heater should be inspected before use and at least annually by a qualified service person. More frequent cleanings may be required as necessary. It is imperative that control compartments, burners and circulating air passageways of the heater be kept clean.
CAUTION: The gas pressure regulator provided with this ap- pliance must be used. This regu- lator is set for an output pressure of 11" W.C. (2.74 kPa).
PROPANE/LP SAFETY
WARNING: For outdoor use only.
ASPHYXIATION HAZARD
•Do not use this heater for heating human living quarters.
•Do not use in unventilated areas.
•The flow of combustion and ventilation air must not be obstructed.
•Proper ventilation air must be provided to support the combustion air require- ments of the heater being used.
•Refer to the Specifications, page 2, heater data plate or contact DESA Heating Prod- ucts to determine combustion air ventila- tion requirements of the heater.
•Lack of proper ventilation air will lead to improper combustion.
•Improper combustion can lead to carbon monoxide poisoning leading to serious injury or death. Symptom of carbon mon- oxide poisoning can include headaches dizziness and difficulty in breathing.
ASSEMBLY
INSTRUCTIONS
Tools Required: |
| |
• | #2 Phillips Head Screwdriver | 1 |
• | Adjustable Wrench | 2 |
Inspect heater components for possible shipping damage. If any is found, immediately notify the dealer. Check to make sure that all components are included with your heater (see pages 10 and 11).
POLE ASSEMBLY
1.Attach legs to base using two bolts, two lock washers and two nuts (see Figure 1). Insert bolts through legs and into top of base. Attach lock washers and nuts from underneath base. Finger tighten only. Repeat for each leg. Do not fully tighten until next step.
2.Secure pole support to legs using two bolts, two lock washers and two nuts. Repeat for each leg. Wrench tighten nuts and bolts from step 1 and 2.
3.Attach ballast weight to base using one, long bolt, lock washer and nut (see Figure 1).
Pole
Support
Legs 
Base
Ballast 
Weight
Figure 1 - Base Assembly
4 | www.desatech.com |