CEILING HARDWARE
|
| 1″ x |
|
| HEAD SCREWS (2) |
| WIRE NUT (4) |
|
CROSSBAR | LAG SCREW AND WASHER | FLAT WASHER (2) |
| ||
(1) |
| |
MOUNTING |
| |
|
| |
BRACKET |
|
|
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked acceptable for ceiling fan support using the mounting hardware provided with the outlet box.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and discon- nect the wiring. Check the ceiling fixture outlet box to be sure that it is marked ‘Approved for ceiling fan mount- ing’. If it is not, a new box must be installed.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Place the wires from the ceiling outlet box to one side of the crossbar mounting bracket. Attach the bracket, with ground wire and ridges down, to the ceiling fixture outlet box with the mounting hardware included with the outlet box. Tighten the screws firmly by hand only, being careful not to bend the bracket by over tightening.
CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.
JOIST
CEILING WIRING
GREEN
GROUND
WIRE
CEILING FIXTURE
OUTLET BOX
(CEILING FAN
RATED)
CROSSBAR
MOUNTING
BRACKET
(RIDGE SIDE
DOWN)
WASHERS
(2)
1” X
SCREWS (2)
LAG SCREW
AND
WASHER (1)
4