SERVICE
Tool service must be performed only by qualified repair personnel. Service or maintenance by unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts and follow instructions in the manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
This manual contains important information regarding safety, operation, maintenance and storage of this product. Before use, read carefully and understand all warnings, cautions, instructions and labels. Failure to do so could result in serious personal injury, property damage or even death.
IMPORTANT SAFETY INSTRUCTIONS
Before using this tool, you need to become familiar with its operation. If you are unsure about the operation of the tool, or have any questions about its proper use, call the Customer Service Department at
•Close and latch the door before operating the Blast Cabinet.
•Check for damaged parts before use. Do not operate the Blast Cabinet if there are damaged parts.
•Maintain proper footing. Make sure you have secure footing and balance.
•Clean spills and sand abrasive in the work area.
SPECIFIC SAFETY RULES AND/OR SYMBOLS
SYMBOLS
The following symbols may be used on your tool. Be familiar with and learn the symbols to operate the tool safely.
Symbol | Name | Description |
V | Volts | Voltage (Potential) |
A | Amperes | Current |
Hz | Hertz | Frequency (Cycles per Second) |
W | Watt | Power |
Kg | Kilograms | Weight |
| Alternating Current | Type of Current |
| Direct Current | Type of Current |
| Alternating or Direct Current | Type of Current |
| Earthing Terminal | Grounding Terminal |
| Class II Construction | Denotes Double Insulation |
min | Minutes | Time |
s | Seconds | Time |
| Diameter | Size of Drill Bits, Grinding Wheels, etc. |
| No Load Speed | |
|
|
|
…/min | Revolutions per Minute | Revolutions, Surface Speed, Strokes, etc. per Minute |
1,2,3… | Ring Selector Settings | Speed, Torque or Position Settings |
ASSEMBLY
Be certain the Blast Cabinet is not connected to a power source before assembly. Plug the Blast Cabinet into a power source only when assembly is complete.
Installing the Legs
1.Unpack the unit and place cabinet, with the viewing window face down, on a table.
2.Loosen the clamp which holds the glove opposite the door and remove glove from mounting ring.
SBCN Abrasive Blast Cabinet Vertical Assembly & Operating Instructions | 5 |