Briggs & Stratton MB (18 HP) ADJUSTMENTS/ Electrical System, Tilt-Up Deck Adjustable Stop

Maintenance Instructions

ADJUSTMENTS/ ELECTRICAL SYSTEM

Tilt-Up Deck Adjustable Stop

When the carrier frame hinge joint is properly ad- justed, the deck lock levers should move in and out of the engaged and disengaged positions freely. All four hitch pins used for height adjustment should sit flush on the washers above the deck pin bushing. On a level surface, if any pin is sticking up (likely the front pins), tighten the opposite side or loosen the same side to lower the pin. Adjustments are made by loosening the jam nut and tightening or loosen- ing the set screws on the Deck Mount Pivot Brack- ets. Retighten the jam nut when the adjustment is complete.

Jam Nut

Set Screw

Tilt-Up Deck Adjustable Stop

ELECTRICAL SYSTEM

For troubleshooting, refer to the Wiring Schematic.

IMPORTANT: Disconnect both battery cables be- fore unplugging any wiring connectors or making re- pairs on the electrical system.

55