Briggs & Stratton 440000, 400000 warranty Engine and Engine Parts, Muffler, Fuel System, Spark Plug

Page 12

MAINTENANCE

ENGINE AND ENGINE PARTS

We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine and engine parts. Use only genuine Briggs & Stratton parts.

WARNING

WARNING

If you perform any maintenance on the engine, first disconnect the spark plug wires from the spark plugs, and disconnect the battery at the negative terminal (electric starter engines only) to prevent unintentional sparking. Unintentional sparking can result in fire or electric shock. Unintentional start-up can result in entanglement, traumatic amputation or laceration. Use only correct tools.

Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation.

Do not tamper with governor spring, links or other parts to increase engine speed.

MUFFLER

AIR COOLING SYSTEM

WARNING

Replacement parts

for the

muffler must be the same and

 

installed in the same position

 

 

as the original parts, other-

 

wise fire can occur.

 

 

If muffler is equipped with spark

 

arrestor

screen,

remove

 

screen for inspection. Replace screen if damaged or plugged.

FUEL SYSTEM

 

Replacement

parts for fuel

WARNING

system (cap,

hoses, tanks,

 

filters, etc.) must be the same

 

 

as original parts, otherwise

 

fire can occur.

 

 

 

 

Debris may clog the engine’s air cooling system. Remove blower housing and clean area shown to prevent overheat- ing and engine damage.

 

CLEAN AREAS UNDER

AIR CLEANER

BLOWER HOUSING

KNOBS

OF ALL DEBRIS

 

CARBURETOR

 

AIR INTAKE

 

SCREWS

FUEL FILTER (if equipped)

FILTER

SPARK PLUG

Use only Briggs & Stratton Spark Tester (part number 19368) to check for spark.

Note: In some areas, local

.030” (0.76 mm)

law requires using resistor

WIRE GAGE

spark plug to suppress igni-

 

tion signals. If this engine

 

WARNING

[1]Disconnect spark plug wires and keep away from spark plugs.

[2]Drain fuel tank or close fuel shut-off valve before replacing fuel filter. Otherwise, fuel can leak out, creating a fire/explo- sion hazard.

was originally equipped with

resistor spark plug, use

same type for replacement.

VALVE CLEARANCE

Check valve clearance yearly. (See Tune-up Specifications on page 6).

12

Image 12
Contents Operating & Maintenance Instructions Table of ContentsPage Hazard Symbols and Meanings Before Operating EngineSafety Before Performing Adjustments or Repairs When Testing for SparkEngine Information TUNE-UP Specifications General InformationModel Series OIL OIL CapacityType of OIL to USE Checking and Adding OILOIL Pressure Switch FuelStarting Type of Fuel to USEStarting and Stopping Electric KEY StarterTo Start Engine To Stop EngineMaintenance MaintenanceEmission Control Changing OILRemoving and Installing AIR Cleaner Pre-cleanerChanging OIL Filter OIL PressureEngine and Engine Parts MufflerFuel System Spark PlugAdjustments Control AdjustmentsCleaning Debris To Adjust Remote Choke ControlCarburetor Adjustment To Adjust Remote Throttle ControlTo Adjust Carburetor Service & Storage ServiceParts List Shipping & Handling **Add State Sales Tax Total Partial List of Genuine Briggs & Stratton PartsStorage CityLimited Warranty Briggs & Stratton Emission Control Defects Warranty Coverage Pièces sous garantie Durée de la couverture