Briggs & Stratton 1687302, 1687286 installation instructions Installation Instructions

Power Steering Conversion Kit		Installation Instructions
		A
	E
G	B	L
		D
		C
		F
H	I
L	J
	K

Figure 17 Power Steering & Hydraulic Hose Installation

A.Power Steering Unit

B.Control Valve Spool

C.Three-way “T”

D.Hydraulic Tube (from Port P to Transmission)

E.Hydraulic Hose (Port T) to “T” fitting

5.Attach existing tube (K, Figure 17), and existing tube

(J) to new three-way “T” (C) as shown.

6.Wrap hydraulic hose (E) (labeled “Port T”) around the back of the power steering unit (A), and attach it to the new three-way “T” (C) as shown.

7.Loop hydraulic hose (I) (labeled “Port E”) around the front of the power steering unit (A), and attach the hose fitting to the control valve spool (B) as shown.

F.Hydraulic Hose (Port P) to hydraulic tube

G.Hydraulic Hose (Port R) to steering cylinder

H.Hydraulic Hose (Port L) to steering cylinder

I.Hydraulic Hose (Port E) to control valve spool

J.Hydraulic Tube to Transmission from “T” fitting

K.Hydraulic Tube from spool to “T” fitting

L.Taptite Screws, 3/8-16 x 3/4

8.Route hydraulic hoses(G) and (H) (labeled “Port R” and “Port L”) out the bottom of the bulkhead heat- shield, and through the frame as shown in Figure 17 and Figure 19.

9.Attach hydraulic tube (D) to hydraulic hose (F) (labeled “Port P”) as shown.

10.Install two 3/8-16 x 3/4 Taptite screws (L) as shown. Tighten all four screws to 30 ft. lbs (40.8 Nm).

2-9