EASYASSEMBLY
Assembling your Pioneer 505 Metal Detector is easy and requires no tools. Just follow these steps:
●Using the supplied bolt and knurled knob, attach the search coil to the lower stem.
●If your model is equipped with a 3- piece stem, open the plastic locking nut on the upper tube by rotating it counterclockwise. Then slide the middle tube into the upper tube, inserting the silver button into the locating hole which is 1/2” behind the plastic locking nut. Now tighten the plastic locking nut.
●Press the button on the upper end of the lower stem and slide the lower stem into the upper stem.
Adjust the stem to a length that lets you maintain a comfortable upright posture, with your arm relaxed at your side.
●Wind the search coil cable around the stem. Leave enough slack in the cable to let you adjust the coil when you are hunting on uneven ground. Then tighten the knob at the end of the search coil.
Note: To adjust the coil, simply loosen the knob.
●Insert the coil’s plug into the matching connector on the control housing. Be sure the holes and pins line up correctly.
Caution:
•Do not force the plug in. Excess force will cause damage.
•To disconnect the cable, pull on the plug. Do not pull on the cable.
Bolt | Knurled |
| Knob |
Search Coil
Bottom view
| Lower | |
| Stem | |
| Upper | |
Lower | Stem | |
| ||
Stem |
| |
| Bottom side | |
Search | Plug | |
Coil | ||
| ||
Cable | Control | |
| ||
| Housing | |
Upper |
| |
Stem |
|
Connector on back of control housing
4