WARNING: If the mower strikes a foreign object, stop the engine. Remove spark plug wire from the spark plug and thoroughly inspect for any damage. Repair the damage promptly before restarting and operating the mower.
Bagging Grass Clippings
You can use the grass catcher bag to collect clippings while you are operating the mower.
•Attach grass catcher following instructions on page 8 of this manual. Grass clippings will automatically collect in the bag as you run the mower.
•Operate the mower till the grass bag is full.
•Stop engine completely by releasing the blade control handle. Make sure that the unit has come to a complete stop.
•Lift discharge door and pull grass bag up and away from the mower to dispose of the grass clippings.
SECTION 6: SERVICE & ADJUSTMENTS
WARNING: Do not at any time make any adjustments without first stopping engine and disconnecting spark plug wire.
Handle Height Adjustment
Your mower is shipped with the handle in the higher height position. To lower the height proceed as follows:
•Remove the starter rope from the rope guide.
•Remove the upper handle by removing the hand knobs and carriage bolts. Lay the upper handle out of the way, being careful not to bend or kink the cables.
•Remove the hairpin clips from the weld pins on the handle brackets and remove the wing nuts and carriage bolts from the upper hole on the handle mounting bracket. Press out on the legs of the lower handle and remove lower handle from the mower.
•Turn lower handle around so the notch on the bottom of the lower handle is facing forward. See Figure 12.
Notch
Lower Handle
Figure 12
•Reassemble, placing the bottom holes in the handle over the weld pins in the handle mounting bracket.
•Place the hairpin clips in the inner holes in the weld pins and insert the carriage bolts the upper hole on the handle mounting bracket and secure with plastic wing nuts. Repeat on the other side.
•Reassemble the upper handle to the lower handle.
•Attach the starter rope as instructed in the Assembly Section.
Cutting Height Adjustment
IMPORTANT: All wheels must be placed in the same relative position.
•For rough or uneven lawns, move the height
adjustment lever to a higher position. This will help stop scalping of the grass.
An adjusting plate and thumb lever at each wheel position provides cutting height adjustment. Each adjusting plate has nine height positions. Height of cut will change when you move the thumb lever from one position to another.
•Simply depress the lever towards the wheel and move the lever assembly to desired position. See Figure 13.
Height Adjustment |
Lever |
Figure 13
Engine Adjustments
Refer to the engine manual for these adjustments.
Replacing Rear Flap
•To remove rear flap, cut off the flat end of the wire rod which secures it to the deck. See Figure 14.
11