ENGLISH | (Original instructions) |
The charger automatically shuts off if the ambient temperature becomes
130oC too high. As soon as the ambient temperature has cooled down, the charger will resume operating.
+40ºC | Charge only at ambient temperatures | |
+10ºC | ||
between 10 °C and 40 °C. | ||
|
Electrical safety
Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rat- ing plate. Never attempt to replace the charger unit with a regular mains plug.
Overview
1.On/off switch
2.
3.Main handle
4.Saw head
5.Sprocket cover
6.Guide bar
7.Chain
8.Chain sheath
9.Lubrication bottle
10.Extension tube
11.Battery
Fig. A
12.Charger
Fitting the saw head (fig. C)
The saw head can be fitted directly to the handle in order to achieve standard reach.
•Align the groove on the outside of the coupling end of the handle (3) with the tongue on the inside of the coupling end of the saw head (4). Push the saw head (4) onto the handle (3).
•Slide the collar (14) down and rotate it clockwise until it is fully tightened.
Warning! Periodically check the connections to ensure that they are tightened securely.
Extending the saw head (fig. D)
The maximum reach can be achieved by fitting the extension tube (10) between the saw head (4) and the handle (3).
•Align the groove on the outside of the coupling end of the handle (3) with the tongue on the inside of the coupling end of the extension tube
(10).
•Push the extension tube (10) onto the handle
(3).
•Slide the collar (15) down and rotate it clockwise until it is fully tightened.
•Align the groove on the outside of the coupling end of the extension tube (10) with the tongue on the inside of the coupling end of the saw head (4).
•Push the saw head (4) onto the extension tube
(10).
•Slide the collar (14) down and rotate it clockwise until it is fully tightened.
Warning! Periodically check the connections to ensure that they are tightened securely.
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (fig. B)
•To fit the battery (11), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place.
•To remove the battery, push the release button
(13) while at the same time pulling the battery
out of the receptacle.
Warning! To prevent accidental operation, ensure that the battery is removed and that the chain sheath is in place on the saw chain before performing the following operations. Failure to do this could result in serious per- sonal injury.
Removing the saw head (fig. C & D)
If the extension tube (10) is fitted, the saw head must be removed first.
•To remove the saw head (4), rest the handle (3) on the ground, loosen the collar (14) and take off the saw head.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (fig. A)
The battery needs to be charged before first use and whenever it fails to produce sufficient power on jobs that were easily done before. When charg- ing the battery for the first time, or after prolonged storage, it will only accept an 80% charge.
8