3. (Figure X) Keep the correct top | 24 |
| THE RBRC™ SEAL |
plate (24) filing angle line of 30° |
| The RBRC™ (Rechargeable Battery Recycling | |
on your file guide parallel with | X |
| Corporation) Seal on the |
your chain (file at 60° from | 60° | indicates that the costs to recycle the battery (or battery | |
chain viewed from above). |
| pack) at the end of its useful life have already been paid | |
|
|
| by Black & Decker. |
4. (Figure Y) Sharpen cutters (25) |
|
| RBRC™ in cooperation with Black & Deck r and other battery |
|
| users, has established programs in the United States to facilitate the | |
on one side of the chain first. File from the inside of each cutter to | collection of spent | ||
the outside. Then turn your saw around and repeat the processes | conserve natural resources by returning the spent | ||
(2,3,4) for cutters on the other side of the chain. Use a flat file to | an authorized Black & Decker service center or to your local retailer | ||
file the tops of the |
|
| for recycling. You may also contact your local recycling center for |
rakers (portion of chain link in | Y | in. | information on where to drop off the spent battery. RBRC™ is a |
front of the cutter) so that they | registered trademark of the Rechargeable Battery Recycling Corporation. | ||
are about .025 inch (.635 mm) |
| 635mm |
|
25 | .025" |
| |
below the tips of the cutters. |
| ACCESSORIES | |
5. (Figure Z) Keep all cutter |
|
| |
lengths equal. |
|
| Accessories are available from your local retailer or nearest |
6. If damage is present on the | Z |
| Black & Decker service center. |
chrome surface of the top |
| Replacement chain accessory number RC800 | |
plates or side plates, file back |
|
|
|
until such damage is |
|
| Replacement bar service part # |
removed. |
|
| WARNING: The use of accessories not recommended in this |
|
|
| manual may be hazardous. |
CAUTION: After filing, the cutter will be sharp, use extra caution | SERVICE INFORMATION | ||
All Black & Decker Service Centers are staffed with trained | |||
during this process. |
|
| personnel to provide customers with efficient and reliable power tool |
NOTE: Each time the chain is sharpened, it loses some of the low | service. Whether you need technical advice, repair, or genuine | ||
kickback qualities and extra caution should be used. It is |
| factory replacement parts, contact the Black & Decker location | |
recommended that a chain be sharpened no more than four times. | nearest you. To find your local service location, refer to the yellow | ||
|
|
| page directory under |
16