Billy Goat FM3301IN, FM3301INE owner manual Cutting Height Adjustment, Blade Clutch

Page 8

16OPERATION continued

16.3CUTTING HEIGHT ADJUSTMENT

CAUTION: DO NOT make cutting height adjustment when engine is running.

Cutting height can be adjusted from 1.0" to 3.5" by placing spacers above or below caster spindles. For easiest adjust- ment change the height on one side at a time. To change cutting height, tilt the unit back, remove lynch pin, remove all spacers then set if off to the side, remove caster rig, add or subtract spacers, reinstall caster rig, place remainder of spacers if any, then reinsert lynch pin (see figure 16-1 through 16-4). Repeat this step on other side.

NOTE: Be sure that the spacers are even on both casters. Running the deck out of level will result in poor cut quality and increased belt wear.

lynch pin

spacers

HIGHEST

LOWEST

CUTTING

CUTTING

HEIGHT

HEIGHT

OF 3.5"

OF 1.0"

caster rig

Figure 16-1

Figure 16-2

Figure 16-3

Figure 16-4

16.4BLADE CLUTCH

The FM mower blade clutch is controlled by an opera- tor presence control. To engage the blade, depress the operator’s left hand control lever against operator’s handle. The blade is disengaged by releasing this lever.(see figure 16-5)

NOTE: The blade clutch must be either fully engaged for cutting or fully disengaged to bring the blade to a stop. Do not operate the unit with the blade clutch partially engaged. Premature belt wear and clutch failure will result from improper operation of the clutch.

CAUTION: Use extreme care when operating the blade. Inspect the work area for foreign objects that could cause damage to the unit or injure the operator if struck by the blade. Never operate the blade with bystanders in the work area. Lever operate the blade without either the discharge deflector chute or the grass catcher in place.

Blade Clutch-

Lever

Fig. 2

Figure 16-5

Operator's handle

Part No. 520188

Page 8 of 20

Form No. F110404B

Image 8
Contents Accessories 7SOUND 8VIBRATIONGeneral Safety Assembly Literature Assy ControlsInstruction Labels Starting Cutting OperationCutting Height Adjustment Blade ClutchStorage PropulsionHandling & Transporting Reconnect Spark Plug Wire Before Servicing UnitAlways Turn Machine OFF, Make Sure ALL Moving Parts Come to a COMCable Adjustments Starter Switch WiringBelt Replacement Blade Removal / SharpeningSpindle Drive Belt Brake Puck Replacement Deck Assembly Parts DrawingEngine Assembly Drive Assembly Parts DrawingHandle Assembly Grass Catcher KIT Transaxle Guard KITTroubleshooting Problem Possible Cause Solution